Upload
others
View
1
Download
0
Embed Size (px)
Citation preview
J.B. Hill Boot Company El Paso Tx 79905 335 N. Clark Drive
(915) 599 1551 Fax # (915) 599 1661 [email protected]
Thank you for your interest in J.B. Hill Boots
Attached are all the documents you will be required to
If you prefer to call our customer service department at 915 - 599 -1551 to discuss leathers or design questions
and place your order over the phone we would be delighted to assist you.
To properly size you we will require you to Measure your feet Outline your feet Complete observation form ( on fitter boots)
We have staff at our factory that can providecustom fittings. If you cannot visit us at our storeor at one of our shows, we have a very successful
fitting program through the mail.
Return the outlines ( thru mail ) along with Fitter Boots
Fitter Boots are an actual pair of Cowboy Boots that we have sent to you to try onthat should be close to your actual size. Please try your "fitter" boots on a carpeted surface
for at least 15 minutes so you will have the opportunity to see if there are any specificareas on the boots that might be bothersome.
complete in order for us to establish your custom size
Order Form
Name
CC#
Exp Date
CSC (3 digit Card Security Code on Back)
Visa, Mastercard & American Express Accepted
Balance due at delivery ( Minimum of 50 % deposit required to start order) Specify amount to charge - ____________
We reserve the right to refuse any orders.
Name
Address
City State Zip
Telephone Email
Leather for To
Leather for Foot Color of Foot
Boot Height
Toe Stitch O Yes O No
Have we made boots for you before? O Yes O No
(Standard men's height 13 inches -womens 11)
Toe Style- Heel Style-
previous stock # ( inside boot)
Leather for Top
Leather for Foot Color of Foot
Boot Height
Toe Stitch O Yes O NoToe Style- Heel Style-
Pulls Style- # 1 or # 4 Initials on your pulls ($90.00) - Block or Script Initials - ____ ____ ____ Color -
Color of Tops
Special instructions - ( if you have inlay's or collars, special request for soles- please specify colors if required )
J.B. Hill Boot El Paso Tx 79905 335 N. Clark Drive
(915) 599 1551 Fax # (915) 599 1661 [email protected]
We can make custom designs, logos, etc. Please call factory for price quotes.
If you prefer to give us a call we would be delighted to take your order over the phone.
If yes please provide
Top Stitch Pattern -
Boot Style Name or Number-
Thread Colors-
Measuring Instructions Part I
Boot Size Width
(Size usually worn)
Heel
Heel
Bone
Bone
He
igh
t
13 height -
11 height -
Long Heel
High Instep
Low Instep
Ball Straight
Ball Angle
Current Height ?
Current Weight?
Current Age?
Straight Ball
Angle Ball
Low instep
High Instep
Straight Ball
Angle Ball
High Instep
Low Instep
Long Heel
High Instep
Low Instep
Ball Straight
Ball Angle
RIGHT FOOTLEFT FOOT
Use Tailors tape. Please check for accuracy as they can shrink or stretch.While sitting in chair, wearing socks you normally wear with cowboy boots.
Best if someone helps you by placing tape completely around foot ( that is dangling)
measure completly around leg while standing.
as shown in illustration, do not draw tape tight, just barely snug.
Do you have any medical or injury issues that we should be made aware of?______________________
Ankle height -
Are your ARCHES - Low or Flat?- ________
Medium - ______
High - ______
Customer Name - _________________________________
LEFT RIGHT
_______ _______
_______ _______
________ _______
CALF MEASUREMENT
Measure completly around leg while standing.
Measuring
Instructions
Part II
Trace right foot here.
Use the other side
of this page to draw
your left foot.
Foot Tracing
1. Put on socks that you regularly wear
with cowboy boots.
2 . Use only a #2 pencil so we know the
diameter, and its radius offset.
3.
4. Hold pencil straight up,
perpendicular to the floor so the
pencil offset is uniform.
90°
Do you have any common
problems you find with footwear?
Entry issues, pinching, rubbing?
Place one foot on the paperEvenly distribute weight on both feet.While looking straight ahead havesomeone else outline your feet.
While Standing.
5. Draw one line only ( USING PENCIL) around each foot.
NAME -
Orders can be faxed or emailed.915 599 1661 FAX
OUTLINES MUST BE MAILED
335 N. Clark DriveEl Paso Texas 79905
* Please Note....If your foot does not fit on this paper
First try placing foot at a diagonal on the paperIf not, please get a longer piece of paper..
FITTER # TOE - HEEL - SIZE – Name –
1.) BOOT ENTRANCEYou should not just fall into the boot. There should be a certain amount resistance and then you shouldpop thru the throat (some pulling and tugging is necessary) This will insure a good fit in years to come.Is fitter easy on and off OR hard on and off? LEFT - _______________- RIGHT-____________________Do you have good resistance? LEFT - _____________________ RIGHT- __________________________
2.) LENGTHThe most important fit parameter is the length from the heel to the ball of the foot. The ball of your foot should fit at the widest point of the boot. This will insure an increasing comfort level as the boot is broken in - (Please make sure your heel is all the way back into the heel pocket).
Is the widest part of your foot sitting in the widest part of the boot? LEFT- __________ RIGHT-__________
FITTER BOOT OBSERVATION FORM
3.) INSTEP
This is top of the foot; some people confuse their instep with their arch (underside of foot). This fit should be snug but not too tight. The instep fit is what holds your foot into the boot heel pocket. If it is sloppy, the boot will not be comfortable to wear for long periods of time as the foot will slide forward in the boot and jam the toes. If it is too tight it will cause fatigue of the foot, at best, and may be painful.
Is the instep ? LEFT / Tight - ____ Good- ____Loose - ____ RIGHT / Tight-____ Good-____ Loose-_____
4.) BALL-
This is the widest part of your foot (normally the big toe joint across foot to small toe joint) There should be plenty of room here and the fit should not put any pressure on the toes or across the ball- Is the ball? LEFT - Tight - ______ Good -______ Loose -_____ Inside or Outside ?________________
6.) TOE ROOM
The toe box should be roomy. Your toes should not be pinched together and you should have toe movement.You should not feel any pressure in this area. -
5.) HEEL SLIP
The heel of the boot should fit snugly, but a certain amount of up & down slippage (typically not more than 1/4 inch), as you walk in a new boot, is to be desired. As theboot is broken in, there will be a slight cupping in the heel area that will hood the heel firmly in place. You should not feel that your heel is unduly unduly constricted or slops around in the heel area. Side to side movement is not desireable, but up anddown is expected. Describe if heel pocket feels correct -
PLEASE RETURN FITTER BOOTS & FITTING DOCUMENTS TO335 N. Clark Drive El Paso Texas 79905
PLEASE MAKE SURE TO TRY ON BOOTS ON CARPETED SURFACE
Can you pinch excess leather over instep- LEFT - ______________ RIGHT - ______________If you can pinch- how much leather / LEFT - ___________________ RIGHT - _____________________
RIGHT - Tight - ______ Good -______ Loose -_____ Inside or Outside ?________________
Do you feel any toe pressure or pinching - LEFT / inside - _____________ or outside-_______________RIGHT / inside - _____________ or outside-_______________
LEFT - __________________________________ RIGHT - ___________________________________
2 5