7/31/2019 Installation Manual Expanded Memory Unit Em-701

1/3

E-1

INSTALLATION MANUAL

15BV97010

EM-701 Expanded Memory Unit

I. Handling lnstructions1. Precautions against static electricity

Keep the expanded memory unit in an antistaticbag while transporting it or storing it.

When working in places where static electricitytends to accumulate, such as on a carpet, dis-charge electricity from your body by touchingany metallic portion before handling theexpanded memory unit.

2. Do not touch the contacts on the expanded mem-ory unit with your hands, as that may result inpoor conductivity.

3. Do not physically damage the expanded memoryunit by dropping it, bending it, etc.

II. Package Contents

III.Installation Procedure[1050/1050P]1. Turn the Main and Sub switches OFF, and unplug

the power cord from the outlet.

2. Remove the back cover of the main body (9screws).

3. Remove the interface cable connector connectedto the hard disk by grasping the pull-tab and pull-ing it out.

4. Remove the printer controller (6 screws).

5. Remove the control board cover of the printercontroller (17 screws).

No. Name Shape Qty

1. Expandedmemory unit

1

2. Installationmanual

1

Back cover

Printer controller

Interface cable

Pull-tab

Hard disk

Applicable Machines: , IP-602M

7/31/2019 Installation Manual Expanded Memory Unit Em-701

2/3

E-2

6. Install the expanded memory unit.

Note:

When installing the expanded memory unit besure that the cutout properly matches the slot onthe motherboard.To install, open both slot clamps, and insert theexpanded memory unit while holding it at a 90-degree angle to the motherboard, until the clamps

click shut.

7. Reinstall the control board cover of the printercontroller (17 screws).

8. Reinstall the printer controller to the main body byaligning it with the pins and securing it with 6screws. Make sure the back connector clicks inwhen it is connected.

9. Connect the interface cable to the hard disk.10. Reinstall the back cover (9 screws).

[IP-602M]1. Remove the IP-602M from the main body, if it is

installed.(1) Before beginning the setup procedure, turn off

the power supply to the IP-602M and the mainunit, then unplug the power cord.

(2) Remove the IP-602M from the main body.

2. Remove the outside cover by removing the twoscrews at the rear of the printer controller.

3. Remove the reinforcement board (2 screws).

Pins

Reinforcement board

Screws

7/31/2019 Installation Manual Expanded Memory Unit Em-701

3/3

E-3

4. Install the expanded memory unit.

Note:

When installing the expanded memory unit besure that the cutout properly matches the slot onthe motherboard.To install, open both slot clamps, and insert theexpanded memory unit while holding it at a 90-degree angle to the motherboard, until the clamps

click shut.

5. Reinstall the Reinforcement board (2 screws).

Note:

Press the reinforcement board in the direction ofthe arrow, then fix it.

6. Reinstall the outside cover (2 screws).

Note:

Reinstall the outside cover by pressing it down so

that it slides into position.

Reinforcement board

Screws