LED Headlight KitImportant: Read all instructions prior to installation.

User ManualPart Number:

LED Headlight KitInstallation Manual

HLV5 Series

Rev Date: V1 04/14/2017Rev Date: V1 04/14/2017

Installation InstructionsH8 / H11 / H13 / P13W / 9004 / 9005 / 9006 / 9007 / 9012 / PSX26W / P13W / 880 / 881

HLV5 Series

WATERPROOF67IP

Installation Instructions H16 / PSX24W

Insert the lamp body until clips engage (as shown).

Secure driver using included wire ties and double sided tape.

Connect bulb to original connector.

Insert lamp body as shown being sure to align locking ring tabs.

Secure using included zip ties and double sided tape.

Connect bulb to original connector

To adjust beam pattern, remove allen screw on locking ring. Rotate bulb body to desired position. Reinstall allen. Ensure LEDs are positioned as in FIG1.

Rotate lamp body until it stops.

HLV5 Series

User ManualPart Number:

Apply Color Filters (Optional)

Installation Instructions 9004/9007

Installation Instructions H1 / H3 / H4 / H7*

LED Headlight KitImportant: Read all instructions prior to installation.

Rev Date: V1 04/14/2017

Included

Safety and Notes

1. Product shall be installed and serviced by a qualified technician.2. LED headlight replacements are waterproof when used in an approved headlight

housing assembly. 3. Good heat dissipation will prolong the working life of the driver, ensure good ventilation.4. Check voltage of the vehicle to be sure it complies with working voltage of the product.

(9~32 VDC)5. Ensure all wire connections and polarities are correct before applying power to avoid

any damages to the LED lights.6. If a fault occurs, return product to Super Bright LEDs. Do not attempt to repair this

product by yourself.

1 - Amber Filters (4 per sheet)1 - Cool White Filters (4 per sheet)2 - Allen Wrench (1.3mm or 2mm depending on model)

MAKE SURE LEDS ARE SHINNING HORIZONTALLY WHEN INSTALLED

FIG. 1

POWER CONNECTOR

HEAT SINK

LAMP BODY

TOP CAP

LOCKING RING

Remove existing headlight dust cover, retaining ring/clip and stock bulb.

Remove the locking ring. Insert locking ring and secure with retaining ring/clip.

Secure driver using included zip ties and double sided tape.

Connect bulb to original connector. Lighting pattern is adjustable

Insert the lamp body as shown.Ensure positon of lamp body and align with slots in locking ring.(Fig1)

1. Remove top cap.2. Slide O-ring and glass over

lamp body.3. Reinstall top cap being careful

not to over tighten.4. Remove Filter from sheet and

wrap around glass.

*H7 bulbs may require an additional adapter/retainer on some Buick, BMW, Ford, Kia, Mercedes, Nissan, and VW/Audi models. Check your vehicle before ordering.

2 - 3M Double Sided Tape4 - Zip Ties

FlangeRetainer*(not included)

1. Remove hex key screw holding mounting flange to bulb, then slide flange off of bulb.2. Align three ears on original retainer with three notches on flange and slide.3. Re-insert bulb into flange then reinstall hex key screw.4. Install bulb into headlight housing and rotate to adjust beam angle. Lock retainer in

place when desired angle is achieved.

*Note: Some Ford models may require the retainer to be trimmed to clear heat sink on bulb.