Fig-01

WALL

PARTS INCLUDED:NO.

1 Screws (D) 6 PCS.

6 PCS.2

ITEM DESCRIPTION QTY.

Anchors (E)

A [2] METAL FINIAL (A1 & A2)

B [2] METAL BRACKET (B1 & B2)

C [1] WIRE 36"

Fig-02

WALL

B1

B2

Fig-03

WALL

C

Fig-04

WALL

B1

B2

C

INDUSTRIAL WIRE PHOTO DISPLAY 36" INSTRUCTIONS

Figure 1 Figure 2

Figure 3

Figure 4

ASSEMBLY INSTRUCTIONS

A1

A2

1. Unpack all parts and place them on a protected work surface.

2. Determine the final location of the Wire Photo Display and mark its placement on the wall surface using the holes in the metal mounting brackets (B1, B2) as a guide.3. Drill pilot holes on each marked location on the wall. Each hole should be just large enough to accommodate the anchors (2). Insert anchors into the holes on the wall (Fig. 1)4. Install the mounting brackets (B1, B2) on the wall using screws through the bracket and in to the wall and anchors (Fig. 2).

5. Hook the wire's end loops (C) over the threaded metal brackets (Fig. 3)

6. Screw the metal finials (A1, A2) clockwise over the threaded metal mounting bracket, securing the wire into place (Fig. 3)

7. Installation is complete (Fig. 4).

IMPORTANT SAFETY INSTRUCTIONS

1. This hanging system is meant for drywall/stud mounting only. If walls are concrete, brick or plaster, please consult your local hardware

store for assistance.

2. Professional installation recommended. However, if you choose to install yourself, two people are recommended.

3. Display is only to be used for lightweight items such as photos and paper, do not overload.