Embed Size (px)
Citation preview
ICTV Prompter Guide Fall 2015
Bringing Scripts from ENPS to Win-Plus
Sending to Prompter from ENPS
Step 1. Initial ENPS Settings 1. Open your rundown in ENPS 2. Click the green rover in the top left corner of your rundown 3. Make sure “MOS Ready to Air” is NOT checked
a. if it is checked, uncheck it by clicking on it 4. Click properties
5. Make sure “On Air” is NOT checked 6. Scroll down and make sure “MOS Control Active” is NOT checked
a. **If either were already checked, hit apply**
Page 1 of 5
ICTV Prompter Guide Fall 2015
7. Scroll down to “MOS Story Send” and make sure nothing is selected 8. Hit apply and then hit go
Step 2. Open Win-Plus 1. On the Teleprompter computer in the studio, open the win plus software 2. If the ENPS window in Win-Plus isn’t already open, click on the “ENPS MOS”
button in the top toolbar
Page 2 of 5
ICTV Prompter Guide Fall 2015
a. **This tells Win-Plus to start listening for ENPS to send it rundowns**
Step 3. Go Back to ENPS 1. Click the green rover and go back to properties 2. Scroll down to “MOS Story Send” and select the studio you are in
a. BDLA is Studio A, BDLB is Studio B
Page 3 of 5
ICTV Prompter Guide Fall 2015
3. Scroll up and click “MOS Control Active” 4. Scroll up and click “On Air” 5. Hit apply and then hit go 6. Go back to the green rover and click “MOS Ready to Air”
Page 4 of 5
ICTV Prompter Guide Fall 2015
Step 4. Go Back to Win-Plus 1. Now when you go back to the Win-Plus window, and you should see your script
there. a. **If it is not there, wait a minute and see if it shows up as sending is not
always instantaneous**
Prompting 1. In order to actually show your scripts on the prompter, click the prompter icon in
the top toolbar 2. In order for your prompter operator to see what the talent sees on the prompter,
click “View” at the very top and then select “Smooth Scroll Prompt Preview”
Page 5 of 5
