Upload
rinceventgf
View
3.535
Download
0
Embed Size (px)
DESCRIPTION
visual instruction for the assembly of the Greg hinged extruder for reprap
Citation preview
eMotion Tech
http://www.reprap-france.com
eMotion Tech
Greg's accessible hinged Wade's
geared extruder
Emotion Tech Greg's accessible hinged Wade's geared extruder
Insert 608zz bearing on the 2cm threaded rod, than insert it in the idler, see picture below.
Fasten the idler to extruder body with the 3cm screw.
Emotion Tech Greg's accessible hinged Wade's geared extruder
Put two 608zz bearings on each side of the extruder, see picture below.
Prepare your hobbed bolt as illustrated below. Adjust the number of M8 washer to face the hobbed
part to the passage of the wire into the extruded (two are enough).
Emotion Tech Greg's accessible hinged Wade's geared extruder
Place the big wheel and bolt on hobbed, add a washer and a nut, then a self-locking nut.
In both holes put two nuts M3 (a hammer may be necessary to drive correctly the nuts)
Emotion Tech Greg's accessible hinged Wade's geared extruder
Prepare two M3 screws 60 mm with a washer and a spring as shown below.
Attach the pulley to the motor with a smmal 3mm screw.
Emotion Tech Greg's accessible hinged Wade's geared extruder
Attach the motor using 10mm screws m3 (it may be advisable to perform this step after mounting
the carriage and hotend x).
Emotion Tech Greg's accessible hinged Wade's geared extruder
Place the hotend on the X carriage.
Screw two nuts and two washers on the rods of hotend, position the X carriage, position the
extruded through the holes indicate by arrows, secure with a washer and nut.