JPT Skylake (H-110) Update BIOS+ME SOP 1. Please check the EFI folder is setting the same as below picture.

(Disk\Removable disk\EFI\BOOT\)

2. Please check the ME_UPDATE place is Disabled(as below picture).

3. Booting to EFI shell mode.

(How to enter the prompt command that please key-in FS0: (have non HDD

device) or FS1: (have the HDD device).

4. Go to the JPT H-110 BIOS folder and key in the update BIOS command

**(FPT.EFI –F XXXXX.ROM) as below picture.

**(FPT.EFI –F XXXXX.ROM -BIOS)

(The “-BIOS” command isn’t included the ME firmware update)

5. After finished, please remove AC power directly.

6. Please remove the ME_UPDATE jumper.

7. Wait 5 seconds, Insert AC power again and then power on the unit.

8. Press DEL to go to BIOS setup menu

9. Press F9 for load BIOS setup default

10. Press F10 for save & exit BIOS menu

11. Done.