8/3/2019 Flexovit Abrasives - Quick Change Sanding Discs
1/1
FLEXOVIT USA, INC
Material Safety Data Sheet FlammabilityUsed to comply with
OSHA's Hazard
Communication Standard, 29 CFR 1910.1200
0
SECTION I - NAME AND PRODUCT
Company Name: Flexovit Abrasives 0 0
Address: 1305 Eden-Evans Road Health Reactivity
Angola, NY 14006 0
Phone: 800-689-3539
Date Updated: Hazard Rating
Product: Quick-Change Sanding Discs NFPA HAZARD RATING CODE
SECTION II - COMPOSITION
% By OSHA OSHA ACGIH Other Carc
ngredient Weight Regulate Cas # PEL TLV Limits oge
SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
Physical State N/A Boiling Point N/A Specific Gravity (H2O=1)
N/AVapor Pressure (mm HG) N/A Freezing Point N/A Odor Threshold
N/A
Vapor Density (Air=1) N/A Melting Point N/A pH N/A
Solubility in Water N/A % Volatile N/A Evaporation Rate N/A
Odor/Appearance Endless mini discs of cloth backing Coefficient
of Water/Oil Distribution N/A
SECTION IV - FIRE AND EXPLOSION DATA
Means Of Extinction Water, CO2, Dry chemical Lower And Upper
Explosion Limits N/A
Flammable Limits N/A Special Fire Fighting Procedures Non
Flash Point N/A Unusual Fire or Explosion Hazards Non
SECTION V - REACTIVITY DATA
Stability: Stable Incompatability (Materials to Avoid): Non
Hazardous Decomposition or Byproducts: None Hazardous
Polymerization: Will not O
SECTION VI - HEALTH HAZARD DATA
Route(s) of Entry Signs and Symptoms of Exposure Emergency &
First-Aid Procedures
nhalation Coughing, shortness of breath Remove to fresh air
Choking sensation if allowed to become very dusty. Obtain first
aid or medical attention
(Nuisance dust, Respirable-5 mg/m3)
Skin May cause irritation by abrasion N/A
SECTION VII- STORAGE HANDLING AND USE PROCEDURES
Steps to be taken in case material is released or spilled:
Normal clean-up procedures
Waste Disposal Method: Standard landfill consistent with
applicable federal, state, and local laws.
Precautions to be taken in handling and storing: Store at room
temperature, relative humidity 25 to 50% 60 to 80% w/
ventilation
Other precautions: Normal precaution should be taken for
nuisance dust particulates generated during grinding operation
SECTION VIII- CONTROL MEASURES
Protection Requirements and Referrals
Respiratory If neededVentilation Local exhaust: Recommended
Mechanical (General): Recommended
Protective Gloves Recommended while handling
Eye Protection OSHA 29 CFR 1910.33
Hearing Protection N/A
Hygienic Practices N/A
Other N/A
COMPANY USE
The information and recommendations set forth herein are taken
from sources and references believed to be accurate
& complete as of the date hereof. However, Flexovit U.S.A.,
Inc. makes no expressed or implied warranty with respect to the
accuracy of the information or the suitability of the
recommendations, and assumes no liability to any user thereof.
11/1/2011
This material contains no ingredients known to retain hazardous
properties of which is defined as hazardous by OSHA
Flexovit Quick-Change Sanding Discs pg 1 of 1
