Upload
others
View
0
Download
0
Embed Size (px)
Citation preview
225 kgsPackaging
Shelf LifeUpto 12 months inour original , unopened,sealed packaging.
ECMAS HP 890is supplied in 225 kgsHDPE barrels.
Description
ECMAS HP 890 is a state of the art super plasticisers based on special ly selected and modif ied Poly-Carboxyl ic Ethers, to produce exceptional performance. It provides good water reduction coupled with good workabil ity retention al lowing production and placing of high qual ity concrete, without any problems of set t ime retardations. Hence, it can be used for production of various grades of concretes. It can be used in different varieties of concretes including those that contain mineral admixtures l ike PFA, GGBS, Metakaolin, Micro Si l ica etc.
Applications
ECMAS HP 890 is used for high-strength and high performance concretes. It is also used for concretes with high f luidity, concretes for pi l ing works and concretes for thin sections where high f luidity is required; concretes for congested reinforcement applications and concretes with high amounts of manufactured sands. It is also used for concretes where conventional super plasticisers cannot give adequate performance.
Usage
ECMAS HP 890 is used general ly at a dosage of range 0.3% to 1.5% by weight of cement. The exact dosage is determined by careful ly done tr ials at project site labs/ready-to-mix concrete plant labs to suit the requirements with local ly avai lable cements/ingredients. The tr ials also are done to check properties both in fresh and hardened state. ECMAS HP 890 is recommended to be added on to wet mix and . . .
TDS / Concrete Admixtures / ECMAS HP 890 / 1 of 2
September 2019
ECMAS HP 890
Physical Form
Colour
Specif ic Gravity
PH Value
Chloride Content
Liquid
Pale Golden Brown
1.07 ± 0.02 @ 27ºC
Above 6
< 0.2%
Physical Properties
7-4-124, Gagan Pahad, InternationalAirport Road, Hyderabad-500052
address 040 24360014 /16 /17phone 040-24360023fax
www.ecmas.co. [email protected]. inemail id
ECMAS HP 890 isin compliance with ASTM C 494 TYPE “G” category BS EN 934-2
It complies withIS 9103-1999, 2007.
STANDARDS
ECMAS HP 890 needsto be stored in shade.Before using thematerial , i t has to beshaken well . Splasheson eyes has to beimmediately washed withplenty of water and seekmedical advice.
Wear al l PPE’s at thetime of the applicationl ike safety boots,goggles, hand glovesand masks. Avoidcontact with skin andeyes. Any direct skincontact with theproducts should bewashed off thoroughlywith soap and water.
Safety Precautions
Storage And Handling
The materials must bestored in a moisturefree, cool and dryenvironment, away fromany direct sun-l ight.
Handle the product(s)very careful ly duringtransportation.
Please avoid stacking ofthe containers.
7-4-124, Gagan Pahad, InternationalAirport Road, Hyderabad-500052
address 040 24360014 /16 /17phone 040-24360023fax
www.ecmas.co. [email protected]. inemail id
TDS / Concrete Admixtures / ECMAS HP 890 / 2 of 2
September 2019
. . . mixed for 2-3 minutes to get proper dispersion and optimum performance. The optimum time of mixing again depends on the mixer capacity/eff iciency etc. ECMAS does not recommend any other different chemical admixtures to be used in conjunction with ECMAS HP 890 unless otherwise, such an event is approved with proper / prior tr ials done in consultation with ECMAS.
Quality Policy
We are committed to provide high qual ity products to ensure highest performance. Each product comes with ECMAS quality stamp is intended to maximize value addit ion and performance of the f inal product. The products are manufactured under a management system independently certif ied to conform to the requirements of the qual ity standards of ISO 9001-2015.
Technical Support
Each user can determine the suitabi l ity of this product in their particular mode of operation. An ECMAS representative wil l be happy to assist in proper selection of al l our products avai lable for commercial use.