DIRECTIONS FOR ASSEMBLY AND ADJUSTMENT

CENTER OF GRAVITY(C.G.)

DECAL:

1 Apply glue on the contact area of the leftand right wing, then glue them together.

7 Install the horizontal stabilizer and verticalstabilizer.

13 Glue the scale exhaust.

2 Secure the wing onto the fuselage with PM3*35mm screws.

8 Secure the rear wheel onto the fuselage with a 1.5mm hexangular screwdriver.

14 Install the propeller.

3 Secure spare parts with PA2.3*5mm screw.

9

15 Install the spinner with PA2.5*8mm screws.

4 Glue the plastic parts.

10

16 Glue the pilot in place.

5 Connect the aileron servos with the Y wires.

11

17 Glue the canopy.

6

12 Glue the scale antenna.

18

DY8966WingspanLengthFlying WeightWing Area Wing LoadRadio SystemPowerBattery

: 1250mm (49.2in): 1003mm (39.48in): 1460g (51.6oz): 26dm² : 56g/dm²: 5 Ch TX and 7 Ch RX : Brushless System: LIPO, 2200 mAh, 14.8V

ASSEMBLY:

DYR-2001 2.4G Receiver

HURC-01 Fuselage

SPARE PART LIST:

HURC-02 Wing HURC-03 Elevator

DY-6015 14.8V 2200mAh25C Battery

BM3720A-KV600 Brushless Motor BM3720A-KV600-ShaftMotor Shaft

DY-3003 Glue

Control Throw Setting Suggestion

Elevator Aileron Rudder

14.8V 2200mAh Li-Po, 25C

(13x7x3)

ESC-skylord 40A

ESC-40A

Lithium-polymer Battery

2200mAh 14.8V25C Discharge

Rechargeable CellsUse li-po charger only

MOTOR

Dynam RC

dynam-rc.cn

of

This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Please recycle.

over

65 70 65 70

1

10 11

923 4

5 719 20

6

HURC-05 Spinner HURC-07 Landing Gear HURC-08 Foam PiecesHURC-06 Pilot

DYP-1020 13*7*3 Propeller DY-1007 9g ServoHURC-13 Decal

0DY-1052 E-Retract ø3.6 90

HURC-12 Push RodHURC-11 Servo HornHURC-09 Plastic Parts HURC-10 Blister Parts

HURC-04 Vertical Stabilizer

Open the canopy this way.

Connect the elevator push rod as shown.Connect the rudder push rod as shown.Secure the stabilizers with PA2.3*20mm screw.

Apply glue on the contact area of the elevator. Glue the elevator onto the fuselage.

glue

PM3*35mm

HURC-15 Cockpit HURC-16 Blade Holder

HURC-14 Moto Mountskylord 40A ESC

DTM-T006 6A Transmitter