Upload
others
View
9
Download
0
Embed Size (px)
Citation preview
Dual-Polarized Array Radiating Elements Based on Electromagnetic Dipole Concept Ridhwan Khalid Mirza1, Yan (Rockee) Zhang1, Dusan Zrnic2 and Richard Doviak2
1Intelligent Aerospace Radar Team, Advanced Radar Research Center, School of ECE, University of Oklahoma 2 National Severe Storm Laboratory, NOAA
• Similar approach is extended to design a stacked ring using full wave spectral
domain analysis with accurate probe feed location.
• Has better matching, return loss, uniform surface current distribution and 200
MHz bandwidth.
• Inner radius1=10mm, Outer radius1=29mm, Inner radius 2=14mm, Outer
radius2=31mm, ε𝑟1=2.2, ε𝑟2=1.07.
Introduction
Dual-polarized radiating element is a critical component in the Multi-functional
Phased Array Radar (MPAR) system and has direct impact on the dual-polarized
array pattern performance. Theoretically, an ideal radiating element consists of
co-linear electric and magnetic dipoles, which ensures the orthogonality of co-
and cross-pol E-fields in all spatial directions. Initial implementation of such
dipole elements has been made by the industry, but much more work remains to
be done to achieve a realistic, low-cost and well-performing engineering design.
The research team at OU in collaboration with NSSL proposed a novel dual
polarized radiating element design based on EM dipole concept. This work
reports the progress and efforts to realize such antenna elements.
Element Designs
1. Loop as Magnetic Dipole
• Loop antennas have advantage of smaller size over its rectangular
counterparts and a careful design can achieve good antenna efficiencies.
• Design Based on cavity theory model and operated in fundamental TM11
dominant mode. Feed point is located on trial and error method.
• Simulation based on Ansoft HFSS. Inner radius=16.902 mm, Outer
Radius=33.804 mm, Rogers 5880 Dielectric Material.
• The next candidate design is loop with periodical capacitive loading and
parallel strip line.
• The parallel strip line helps to maintain 50Ω impedance and capacitive loading
of comprising of several arc strip line sections at 45 degree each allows the
current along the loop to remain uniform and in phase.
• The constant current along the loop allows it to be considered close to a
magnetic dipole at far field with horizontally polarized omnidirectional pattern.
2. Electric Dipole Element Designs
Paper ID: 274605 37th AMS Conference on Radar Meteorology, Norman, Oklahoma. 14 – 18 September 2015
This work is supported by NOAA-NSSL through grant #NA11OAR4320072 , Any opinions, findings, and conclusions or
recommendations expressed in this publication are those of the authors and do not necessarily reflect the views
of the National Ocean and Atmospheric Administration.
CONTACT: [email protected] Tel: (405)-325-6036
School of Electrical & Computer Engineering
Summary
The main challenge of combined EM dipole is the magnetic dipole performance
and controlled interaction between E and H dipoles. The current goal is to
achieve a realistic, low-cost and well performing engineering designs. The
research team at OU is working towards testing the initial designs in the anechoic
chambers as a part of a larger array test bed called Configurable Phased Array
Demonstrator (CPAD) at the Radar Innovations Laboratory (RIL).
Figure 2: (a)Proposed Stacked Ring with Coax Feed (b) Return Loss(dB) (c) Total 3-D radiation pattern (d) Radiation Pattern E Plane (Y-Z) (e) Radiation Pattern H Plane (X-Z)
(a) (b)
(d) (e)
(a) (b) (c)
Figure 1: (a)Proposed Single Layer Ring with Coax Feed (b) Return Loss(dB) (c) Total 3-D radiation pattern (d) Radiation Pattern E Plane (Y-Z) (e) Radiation Pattern H plane (X-Z)
(d) (e)
(c)
Figure 3: (a) Loop with using differential feed (b) Return Loss (dB) (c) Fabricated
Prototype
(a) (b) (c)
(c) (b) (a)
Figure 4: (a) Radiation Pattern E Plane (XZ) (b) Radiation Pattern H Plane (YZ)
(c)Total 3D Radiation Pattern
References
[1] Ramesh, Garg, et al. "Microstrip antenna design handbook." Artech House(2001): 308-311. [4] Balanis, Constantine A. Antenna theory: analysis and design. Vol. 1. John Wiley & Sons, 2005. [2]Kokotoff, David M., James T. Aberle, and Rod B. Waterhouse. "Rigorous analysis of probe-fed printed annular ring antennas." Antennas and Propagation, IEEE Transactions on 47.2 (1999): 384-388
[3] Wei, Kunpeng, Zhijun Zhang, and Zhenghe Feng. "Design of a wideband horizontally polarized omnidirectional printed loop antenna." Antennas and Wireless Propagation Letters, IEEE 11 (2012): 49-52.
• The Investigation of E dipole led to various implementations of half wave length
dipoles. Among all we chose the planar dipole which allows us to avoid 3-D
geometry structure.
• The current focus is quality of pattern rather than antenna bandwidth.
• For the sake of brevity only results of Planar E dipole are shown below. The
dipole arms are fed at the center as seen in figure 5.
E- Plane H- Plane XZ- Plane
Figure 5: E Dipole Element Design and their simulated Results
3. Combined EM Dipole as A Radiating Element
• These element designs can be combined in such a manner to ensure the
orthogonality of co-pol and cross- pol fields in all spatial directions.
• According to the basic theory [4], Eloop=Hdipole and Hloop=Edipole when certain
conditions are met.