Embed Size (px)
Citation preview
DRONE HUNTER X User Manual
User Manual
TABLE OF CONTENTS
Section 1 Safety Instructions ...............................................................1-1
Section 2 Unpacking ............................................................................2-1
Package Contents ....................................................................................................2-1
Section 3 Operation .............................................................................3-1
How to Use Drone Hunter X ..................................................................................... 3-2
How to Remove the Battery ..................................................................................... 3-4
How to Recharge the Battery ................................................................................... 3-4
LED and Alarm Indicators ........................................................................................ 3-5
Section 4 Specifications ......................................................................4-1
General Specifications ............................................................................................. 4-1
Jamming Frequency ................................................................................................. 4-2
Lithium-ion Battery ..................................................................................................4-2
Battery Charger .........................................................................................................4-2
Section 5 Warranty Terms & Conditions ...............................................5-1
Section 6 Appendix ..............................................................................6-1
Glossary of Terms ....................................................................................................6-1
Contact Information ................................................................................................. 6-2
1.0 Safety Instructions
User Manual Page 1-1
SAFETY INSTRUCTIONS
1. Do not drop, disassemble, open, crush, bend, deform, puncture, shred, microwave, incinerate, or paint the device.
2. Do not use the device if it has been damaged—for example, if cracked, punctured or harmed by water. Disassembling or puncturing the battery (whether integrated or removable) can cause an explosion or fire.
3. Do not use in a location subject to high temperature, low temperature, or high humidity. Doing so may cause fire or electric shock.
Refer to the specifications on page 4-1.4. If any unusual smells or smoke come from the unit, stop using the product.
In such a case, immediately disconnect the power source and contact the manufacturer. Continued use in such a condition may cause fire or electric shock.
5. Do not disassemble, modify, or repair your device on your own. In case of unauthorized disassembling or modifications to your device, you can be void your manufacturer’s warranty.
Improper disassembly may cause fire or permanent damage to your device.6. Do not store your device near other electronic equipment.
Avoid storing your device near heaters, microwaves, etc., as this may cause battery leakage/overheating.
7. Handle with care. Do not drop your device as any kind of bents/deformations can cause device malfunction.
8. Ensure maximum battery life. Please do not store the battery in a fully discharged state. Even when the device is not in use, make sure to fully charge the battery once a month.
Avoid overcharging as this may lead to shortening of the battery life.
9. Be careful while cleaning. Wipe your device/battery with dry cloth. Do not use chemicals or detergents.
10. Keep the device in a place with good ventilation.11. Keep the device out of the reach of children.12. Do not use the device for anything other than its intended use.
1
2.0 Unpacking
User Manual Page 2-1
UNPACKING
2.1 Package Contents The following equipment and documentation are included in the Drone Hunter X package.
ቻ Drone Hunter X (includes battery 1pc.)
ቻ Battery x 3 ቻ Battery Charger
ቻ User Manual ቻ Transit Case ቻ Power Cord
» If any of the above items is damaged or missing, contact your retailer.
2
3.0 Operation
User Manual Page 3-1
OPERATION
5
2 3 41
1 HandleHandle to carry the equipment.
2 Power ButtonWhen the power switch is turned ON, a red LED will light up. Press the power switch again to turn it off.
3 GPS ButtonWhen switched ON, a blue LED will light up indicating the GPS jamming signal is selected. Press the switch again to turn it off.
4 BatteryThe Drone Hunter X radiates jamming signal more than 30 minutes with a fully charged battery unit.
5 Trigger ButtonWhen switched ON, the trigger switch makes a buzzer sound and starts radiating a jamming signal. Press the switch again to turn it off)
3
3.0 Operation
User Manual Page 3-2
3.1 How to Use Drone Hunter X
Press the power button once to turn on the jammer, the power light (red) turns on.
Press the power button again to turn off the Drone Hunter X.
Press the trigger button once to radiate jamming signal indicated by a beep sound once per second.
Press the trigger button again to stop radiating the jamming signal.
Align and slide the battery into the main unit. Lock knob will click and automatically lock as the battery is attached.
Press the GPS button once to activate GPS jamming, the GPS light (blue) turns on.
Push the GPS switch again to deactivate GPS jamming, the GPS light (blue) turns off.
3.0 Operation
User Manual Page 3-3
✓ RF jamming disrupts the radio frequency link between the drone and its operator by generating large volumes of RF output. Once the RF link, which can include Wi-Fi links, is severed, a drone will either descend to the ground or initiate a “return to home” maneuver.
✓ GPS jamming disrupts the drone’s satellite link, such as GPS or GLONASS, which is used for navigation. Drones that lose their satellite link will hover in place, land, or return to home.
✓ Jamming is successful when the jamming signal is powerful enough to disrupt the RC signal received by the drone. This depends on many factors, such as the distance between the antennas, the orientation of antennas, line-of-sight conditions, the presence of other strong signals in the area and environmental effects such as reflection and refraction.
NOTES
3.0 Operation
User Manual Page 3-4
3.2 How to Remove the Battery
3.3 How to Recharge the Battery Charge the battery by placing it in the battery holder.
When charging, a red LED flashes up. When completely charged, the LED will turn into green.
Full charge time is less than 4 hours.
Locate the lock knob on the back side of the battery.
Push the lock knob upward to unlock the battery.
Pull out the battery from the main unit.
3.0 Operation
User Manual Page 3-5
3.4 LED and Alarm Indicators
Power LED Alarm Description Solution
Blinks 2 times per second
Beeps 3 times per second
Low Battery Replace Battery
Blinks once per second
Beeps once per second
High TemperaturePress the trigger switch to stop radiating and use again after cooling
Blinks 2 times per second
-Failure to Initiate Radiation Due to Low Battery
Replace Battery
Blinks once per second
-Failure to Initiate Radiation Due to High Temperature
Use again after cooling
✓ Overheated jammers can fail to jam the targets.
✓ Be careful when using this device, it can block all radio communications on any device that operates on radio frequencies within its range.
✓ Do not radiate signals directly toward the wall; the signals can be reflected.
NOTICE!
4.0 Specifications
User Manual Page 4-1
SPECIFICATIONS
4.1 General Specifications
Description Specification
1 Jamming Signals GPS, GNSS, 2.4GHz ISM, 5.8GHz ISM
2 Antenna Directional antenna Gain: 9dBi or more
3 Operation Time 30 minutes
4 Jamming Distance 1,000m
5 Weight 7kg (with the battery unit)
6 Dimension 1,024 x 307 x 98mm
7 Operating Temperature -20 to +55℃
8 Operating Humidity Less than 90% RH
9 Ingress Protection IP55
10 Battery Type Rechargeable Lithium-ion
4
4.0 Specifications
User Manual Page 4-2
4.2 Jamming Frequency
Description Specification1 Capacity 6.7Ah2 Nominal Output Voltage 25.2V3 Max. Charge Voltage 29.4V4 Nominal Charge Current 2A5 Max. Charge Current 5A
6 Discharge Current Continuous Current: 12A Peak Current: 18A
4.3 Lithium-ion Battery
4.4 Battery Charger
Description Specification1 Rated Input Voltage AC 100 — 240V 2 Input Voltage Frequency 50/60Hz3 Output Voltage 29.2V±0.2Vdc4 Charge Current 2A
Description Frequency Range1 GPS L1 1,560 — 1,620MHz2 GPS L2 1,205 — 1,250MHz3 ISM 2400 2,400 — 2,484MHz4 ISM 5800 5,730 — 5,850MHz
5.0 Warranty Terms & Conditions
User Manual Page 5-1
WARRANTY TERMS & CONDITIONS
1. Free Maintenance Support The Drone Hunter X warranty covers the device and its related accessories against manufacturing defects up to 1 year from the shipping date.
During the said applicable warranty period, Dymstec will provide necessary maintenance support to repair or replace the device in case of defects at free-of-cost.
The target product includes all products supplied by the company.2. Paid Maintenance Support
Please note that charges will incur in case of the supply of any additional requirements after the device delivery.
After the initial warranty contract period is over, we offer a paid-maintenance support contract as per the customer requirement.
3. This limited warranty does not cover minor imperfections like marks, scratches, etc., which do not alter the device functionality.
4. In case of any missing part(s) and/or faulty packaging which does not comply with the sales contract, a report should be made within 7 days from the date of device delivery, failing which, the company shall not bear any responsibility whatsoever.
5. Sales Contract and Proof of Purchase are necessary to be eligible for the warranty service.
6. Repairs under warranty shall be carried out by the authorized company personnel only.
7. This warranty holds good only to the purchaser specified in the sales contract and is not transferable.
8. The customer must pay for all transportation and insurance charges for sending the unit to be repaired.
9. Limitations of Coverage – This warranty does not cover:i. Damages caused while unpacking, installation, and maintenance.ii. Damages/faulty conditions due to the repairs made by anyone else other than
the authorized company personnel.iii. Errors/failures due to the usage of unauthorized accessories like battery etc.iv. Repairs due to operator negligence, improper usage of electrical supply
voltage, wear & tear, etc., v. Repairs due to environmental factors like dust, corrosion, excessive heat,
chemical reactions, etc.
5
6.0 Appendix
User Manual Page 6-1
APPENDIX
6.1 Glossary of Terms
6
Term Description
GPS Global Positioning System
GPS L1 GPS L1 Band Frequency (1575.42 MHz)
GPS L2 GPS L2 Band Frequency (1227.60 MHz)
GNSS Global Navigation Satellite System
ISM Industrial, Scientific and Medical Radio Bands
ISM 2400
2.4GHz ISM Frequency Band: Available world-wide and devices such as Wi-Fi, Bluetooth, ZigBee, Microwave Ovens, PC Peripherals, etc. occupy this band
ISM 58005.8GHz ISM Frequency Band: Available world-wide and devices such as Gaming Controllers, Cordless Phones, Baby Monitors, etc. occupy this band
IP 55
Ingress Protection First Digit (Solids): Protects from limited dust ingressSecond Digit (Liquids): Protects from low pressure water jets from any direction, limited ingress protection
LED Light Emitting Diode
RH Relative Humidity
6.0 Appendix
User Manual Page 6-2
6.2 Contact InformationName Dymstec, Co., Ltd.
Address #1308, 388 Dunchon-daero, Jungwon-gu, Seongnam-si, Gyeonggi-do, 13403, South Korea
Telephone +82 31-777-8450
Fax +82 31-777-8933
Email [email protected]
Website http://www.dynamicshielding.com
http://www.dynamicshielding.com
