*** DiskCheckup V3.3 Build: 1000 Report ***SysInfo DLL Version: SysInfo v1.0 Build: 1090Time of export: 16:19:32 19-Mar-2015Device information: Device ID: 0 Interface: SATA Device Capacity: 476937 MB Serial Number: 5VJ71KTE Model Number: ST9500420AS Firmware Revision: 0006HPM1 Partitions: C: 141666 MB D: 134694 MB E: 176460 MB F: 24011 MBATA information: Disk geometry: Cylinders: 60801 Tracks/Cylinder: 255 Sectors/Track: 63 Bytes/Sector: 512 Total disk sectors: 976773168 Logical sector size: 512 Physical sector size: 512 Media rotation rate: 7200 RPM Buffer size: 16384 KB ECC size: 4 Bytes Standards compliance: ATA8-ACS Supported: Yes ATA/ATAPI-7 Supported: Yes ATA/ATAPI-6 Supported: Yes ATA/ATAPI-5 Supported: Yes ATA/ATAPI-4 Supported: Yes Serial/Parallel: Serial SATA 3.0 Compilance: No SATA 2.6 Compilance: Yes SATA 2.5 Compilance: No SATA II: Ext Compilance: No SATA 1.0a Compilance: No ATA8-AST Compilance: No World Wide ID: 5000C50029A2891F Feature support: SMART supported: Yes SMART enabled: Yes SMART self-test supported: Yes SMART error log supported: Yes LBA supported: Yes IORDY supported: Yes CFast supported: No DMA supported: Yes Maximum Multiword DMA mode supported: 2 Multiword DMA selected: None Maximum UltraDMA mode supported: 5 UltraDMA selected: 5 Maximum PIO mode supported: 4 SATA Compliance: Yes NCQ priority information supported: No Unload while NCQ commands are outstanding supported: Yes Phy Event Counters supported: Yes Receipt of power management requests supported: No NCQ feature set supported: Yes SATA Gen2 Signaling Speed (3.0Gb/s) supported: Yes SATA Gen1 Signaling Speed (1.5Gb/s) supported: Yes Software Settings Preservation: Supported, Enabled In-order data delivery: Not supported Initiating power management: Supported, Disabled DMA Setup auto-activation: Supported, Disabled Non-zero buffer offsets: Not supported Trusted Computing supported: No Host Protected Area (HPA) supported: No Read look-ahead supported: Yes Read look-ahead enabled: Yes Write cache supported: Yes Write cache enabled: Yes Power management supported: Yes Security mode supported: Yes Security mode enabled: No Device Configuration Overlay (DCO) supported: Yes 48bit Addressing supported: Yes Auto Acoustic Managment (AAM) supported: No Power-up in Standby (PUIS) supported: No Advanced Power Management (APM) supported: Yes Advanced Power Management (APM) enabled: Yes Current APM level: Minimum power consumption without Standby CompactFlash Association (CFA) supported: No General Purpose Logging (GPL) supported: Yes Streaming supported: No Media card pass through supported: No Extended power conditions supported: No Extended status reporting supported: No Write-read-verify supported: No Free-fall control supported: No TRIM command supported: No SCT command transport supported: Yes NV Cache enabled: No NV Cache Power Management supported: No