07610-004-34-16-A

I/O MODULE REPLACEMENTDISHSTAR SERIES/ DELTA HT-E-SEER

1 of 3

WARNING: This part should be installed only by qualified service personnel to reduce the risk of electric shock, serious injury, or fire. A plumbing permit and the services of a licensed plumber and electrician might be required in some areas.

Turn off the power supply and place the dishwasher disconnect (if applicable) in the off position. Lockout/tagout to prevent the power supply from being turned back on inadvertently.

CAUTION: Failure to install this part within the guidelines might adversely affect safety, performance, component life, and warranty coverage.!

CAUTION

!WARNING

DISHSTAR/DELTA I/O MODULE KIT - 06401-004-76-15

TOOLS REQUIRED• 7/16” Wrench• Phillips Screwdriver

PARTS INCLUDEDQTY DESCRIPTION PART NUMBER

1 I/O Module 05945-004-36-341 Instructions, I/O Module Replacement 07610-004-34-16

1. Remove front panel using 7/16” wrench and set aside.I/O MODULEREPLACEMENT

7/16” wrench used in this step.

07610-004-34-16-A

I/O MODULE REPLACEMENT DISHSTAR SERIES/ DELTA HT-E-SEER

2 of 3

I/O MODULEREPLACEMENT

2. Locate I/O module and take note/picture of how wires are connected.

3. Remove wires.

4. Remove old I/O module using phillips screwdriver.

5. Place new I/O module from kit in the same place, oriented the same way, and secure using phillips screwdriver and hardware removed in last step.

6. Connect wires to new I/O module (reference note/picture taken in Step 2).

7. Replace front panel using 7/16” wrench.

8. Restore power to machine.

9. Turn machine on by pressing Power Button.

To access programming, the machine must be on

and not in cycle.

Phillips screwdriver used in this step.

CAUTION! Pictures showing wires are

examples. Take note/picture of actual wires on

machine for reference.

!CAUTION

I/O module from kit used in this step.

Location of I/O module on control panel varies

by model.

7/16” wrench used in this step.

07610-004-34-16-A

I/O MODULE REPLACEMENT DISHSTAR SERIES/ DELTA HT-E-SEER

I/O MODULEREPLACEMENT

10. Press and hold I and III Buttons until “Program” starts flashing (2–3 seconds).

11. Press Select Button.

12. Use Up-arrow or Down-arrow Button to change the program number to “8.”

13. Press Select Button (“Program” will flash).

14. Press Delime Button to exit.

15. Machine is now ready for operation.

The programming buttons (Up-arrow, Down-arrow,

and Select) are hidden on the display and are shown

here as red outlines.

P R O G R A M

P R O G R A M

8

3 of 3