DESCRIPTION: Eco-Etch™ is available in a liquid (PRO) or (GEL) version. They are a safe alternative to muriatic or phosphoric acids used to etch cementitious surfaces required to achieve optimum bonding for stains, coatings, and sealers. Unlike conventional acids, Eco-Etch™ will not burn skin or corrode metals. Additionally, it contains cleaning agents to make the surface look virtually new. The Gel viscos­ity is ideal for uneven, vertical wall, precast concrete structures, and artistic etching.

Our industry changing organic based chemistry makes high performance possible without toxic solvents, harmful acids, or dangerous fumes. No flammability, combustion, or corrosion concerns. Eco-Etch™ not only meets the most stringent V.O.C. regulations, it is engineered to be the safest and most sustainable high performance concrete etcher on the market today. Sustainability, performance, and value are the cornerstones of the entire EcoProCote™ brand without compromise.

INTENDED USE: Use for proper profiling of concrete for optimum penetration and bonding of stains, sealers, and coatings. Achieve a CSP-1 to CSP-2 surface profile on cementitious surfaces with correct application and dwell times.

PACKAGING: 1 Gallon Jug, 5 Gallon Pail, 55 Gallon Drum, 275 Gallon Tote

The Smarter Way to Etch & Clean I Lowest Cost Per Sq.Ft. • GEL or Liquid Options

No Hazmat Concerns • Work in Occupied Spaces No Respirators Required • Safe on Metals

TECHNICAL DATA: V.O.C. Content = < 0 g/LFlash Point= Non Flammable Freeze Point= 32° F / 0° C

Eco Etc ™

HEALTH D

FLAMMABILITY Iii

Hazardous Components= None PHvs1CALH AZARo 0 Protection B: Protective Gloves •--------• & Safety Goggles. PERsoNAL P RoTEcr10N [!]

INGREDIENT DISCLOSURE: INGREDIENTS Organic Salt Mixture Water Solvent Free Thickeners Solvent Free Surfactants

CAS# N/A (Non-Haz) 7732-18-5 N/A (Non-Haz) N/A (Non-Haz)

100% Biodegradable I Non-Hazardous I Zero voe

Non-Fuming I Non-Corrosive I Achieve CSP-1

150-200 Sq.Ft. Dwell Time Installation Water Rinse to

Coverage 1-15 Minutes Temp. 40°F-95

°F Neutralize

(Surface should be dry)

POTENTIAL USGBC LEED POTENTIAL: MR Credit 1-Building Reuse, MR Credit 3-Materials Reuse, MR Credit 5-Regional Materials, MR Credit 6-Rapidly Renewable Materials, IEQ Credit 4-Low Emitting Materials, ID Credit 1-lnnovation in Design.

LIMITATIONS: Refer to the installation guide for full application instructions. You may download the guide at: www.ecoprocote.com. Calcium and lime must be present in the substrate for etching reaction. Thorough rinsing with water must be performed, usually within no more than 15 minutes from time of application.

Eco Safety Products �Smazter Chemistry. Performance Engineered.

Phoenix, Arizona U.S.A. Distributed By

GarageFlooringLLC.com Made in the USA

Available At: