Upload
mohgan-raj
View
214
Download
0
Embed Size (px)
Citation preview
8/22/2019 CSM-C
1/5
Configuration Of DS350 Series:
Step 1:Open CSC-350 Configuration Software. It
appears as shown below.
Step 2:Select Online Config from the window which
is shown above.
(Note: Online config mode works only when CS
Instrument is Connected to the compute Via USB. While
Offline Config is used to configure the device which
is not connected to the computer at present. You can
also read a saved configuration file from the hard
disk by clickin on the Load configuration from File
Option.)
Step 3:Click Auto Detect From the Window shown above.
It Will Show you a list of devices which is connected
to the computer at present. Select the Device which
you want to configure and click ok the Following
window will appear on the screen as shown below.
8/22/2019 CSM-C
2/5
Step 4:IN Device Information Screen, you will find
the information about the Device like Serial Number,
Device address, Firmware Version etc.
Step 5:In Sensor Input Screen, you need to
configure what type of sensor used in the terminals
as shown below. There are four Kinds of terminals as
shown below.
8/22/2019 CSM-C
3/5
Step 6:Select the sensor type for each terminal with
the wiring and which is given above. Note that the
sensor type and the wiring terminal should be correct
in order to get the values from the field.
Step 7: In Modbus Master Screen, Set the values of
the communication Protocol you are using like Baud
rate, time out, delay, type of Device etc.
Step 8: In Virtual Channel Screen, Create the
number of channels that you have connected to the
Device with their unit.
Step 9:In Display Screen, Configure the Display ofthe display according to Channel as shown below. You
can create Different Pages to display in the Device
screen by clicking Add Page in the dialog box shown
below.
8/22/2019 CSM-C
4/5
Step 10:Alarms can be set for the channels with the
values in the Alarms screen.
Step 11:In Time & Logging Screen, the values to
logged is configured. You can modify the logging
conditions, Logging intervals (i.e) the time
intervals for each log and the description of the
logging file .
8/22/2019 CSM-C
5/5
(Note: In Time & Logging Screen there are two
columns present in the bottom of the screen. The left
column shows the number of channels configured in the
Device and the right column shows the number of the
channel values which is logged.)
Step 12:In Field Bus Interface Screen, there will
be two options which is shown below.
Select the communication protocol you are using, it
can be RS-485 or Ethernet.
(Note: If you are using RS-485 you have to give the
address of the protocol you are using. If you are
Ethernet, you have to specify the IP of the Device or
you can select the device to obtain the IP
automatically with respect to the network it is
connected.)
Step 13:Finally, you can download the configuration
directly to the Device which is connected or you can
save the configuration in the hard disk for further
use.