PowerPoint Presentation
GROUP 3S.O.PHow To make LAN cable(Local area Network)Members
Group :Elfina Rahmania(08)Esti Widiyanti(09)Finda
Wahyuni(10)Musyarifatul M(16)Tika Sofiani(27)Tyas desnia R(28)Class
: XII-TKJ2Tools that need to be prepared
Tang CrimpingRJ45UTP cableLAN tester
How to Make UTP Cable / LAN1. Cut the cable length as
needed.
2. Open the outer rap cable, along the little finger. Carefully
small cable inside the cut.3. Sort-sequence of small wires in it to
make it straight, to be easily inserted into the connector
RJ45.
The Straight cable, sequence of PIN 1-81. Orange White2.
Orange3. Green White4. Blue5. Blue White6. Green7. Brown White8.
Brown
Cross cableThe sequence at the end of the cable to 2:1. Green
White.2. Green.3. Orange White.4. Blue.5. Blue White.6. Orange.7.
Brown White.8. Brown.
4. Put the cable into the connector RJ45, make sure all ends up
stuck in the connector. To be bitten by a copper cable
connector.
6. And then, you're done.
5. Pinch the connectors using crimping pliers, cable position
not to be interested, or make sure the cord is correctly seated.7.
Test UTP cable with a cable tester, a tool to test the results of
our cable, indicator is quite easy, you just pay attention to the
lights on the cable tester. Make sure the 8 light is sequentially
without anyone dying.
Good Luck !And Thanks for you attention See you next time Fire
FliesOwl Citynull231485.8
