Website: paracordgalaxy.com Email: support@paracordgalaxy.com Phone: 844-727-2267Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our website.

Cobra with Dog Tag Shoelace CharmMaterials

8-10 feet of 550 paracord in one colorOR4-5 feet of 550 paracord in two colors

Shoelace Charm or Dog TagBuckle

{Cost for this project starts at about $3}

1 foot 550 paracord without the inner strands

Step 1: Find the middle of your cord and insert it down through one end of your

buckle.

Step 2: Bring both ends of your paracord down through the loop and pull it tight.

Step 3: Insert the ends of your paracord down through the other end of your

buckle. Measure the desired length for your bracelet.

Step 4: Bring the working end of the cord on the right, A, over your center cords and

under cord B.

Website: paracordgalaxy.com Email: support@paracordgalaxy.com Phone: 844-727-2267Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our website.

Step 5: Bring cord B behind the center cords and up through the loop created by

cord A.

Take your 1 foot piece of paracord and insert one end through the center of the

cords as shown. Then pull A and B tight.

Step 6: Bring A over the center cords as well as your 1 foot piece and under B.

Step 7: Bring B behind the three cords in the center and up through the loop

created by cord A. Pull tight.

Step 8: Lift your 1 foot piece of cord, C. Then take A and cross over the center

cords and under B.

Step 9: Take B behind the center cords and up through the loop created by A,

then pull tight.

Website: paracordgalaxy.com Email: support@paracordgalaxy.com Phone: 844-727-2267Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our website.

Repeat steps 6 through 9 until you are a little less than half way done. Thread your

dog tag onto cord C as shown.

Continue repeating steps 6 through 9 until you reach the length of your dog tag.

Once you reach the length of your dog tag, insert cord C up through the other end of the tag. Continue with steps 6 through 9 until you reach the end of the bracelet.

Before your last knot, insert cord C down through the center of the cords as shown,

leaving a small loop.

Repeat one last knot with cord A going through the loop in cord C. Pull all cords

tight.

For added security, use forceps to weave cord C under the knots in the back of the

bracelet. Melt and trim all ends.