MV-65MAINTENANCE

MANUAL:

CNC Diversified

Information located in MV-65 maintenance manual, section C.

MAINTENANCE GUIDEMACHINE: MV-65

DAILY:Check coolant levels and concentration (See Figure 1-Coolant Tank Location). Add

water, coolant, or both if necessaryCheck oil levels, add if necessary (See Figure 2-Way Oil Tank and Figure 3-Spindle

Oil Cooler for tank locations)Clean inside of machine of excess chipsEmpty waste oil container (See Figure 6-Waste Oil Container)

MONTHLY:Clean air filter on spindle oil cooler (See Figure 3-Spindle Oil Cooler)Check way oil levels. This is located on the back of the machine (See Figure 2-Way

Oil Tank). The proper oil is TELLUS 68Check oil level in the spindle oil cooler (See Figure 3-Spindle Oil Cooler). This is

located on the back side of the machine. The proper oil is TELLUS C5, although TELLUS 32 may be used as an alternative.

Check oil level on spindle. The sight glass is located on the right side of the spindle (See Figure 4-Spindle Oil Level Sight Glass). The proper oil is TELLUS C5, although TELLUS 32 may be used as an alternative.

6 MONTHS:Pull and drain coolant tanks, vacuum all debris from the tanks, and replenish with

fresh coolantClean off debris from cooling fins from the spindle oil cooler. This is done by

spraying degreaser on the fins, and then gently using compressed air to remove debris.

Pull back way covers for X and Y-axis. Clean out excess chips and debris, clean all sensors, and check for leaks and damage to the system.

YEARLY:Replace spindle oilReplace way oilChange “D” cell batteries located in the electrical cabinet (See Figure 5-Battery

Location). This must be done with the power on and the machine operable. Be sure to replace batteries exactly as you found them, or else the machine will lose all memory (such as offset values etc) and become inoperable.

Information located in MV-65 maintenance manual, section C.

MAINTENANCE VISUALSMACHINE: MV-65

Figure 1-Coolant Tank Location

Figure 2-Way Oil Tank

Information located in MV-65 maintenance manual, section C.

Figure 3-Spindle Oil Cooler

Figure 4-Spindle Oil Level Sight Glass

Information located in MV-65 maintenance manual, section C.

Figure 5-Battery Location

Figure 6-Waste Oil Container

Information located in MV-65 maintenance manual, section C.