Upload
others
View
0
Download
0
Embed Size (px)
Citation preview
Closing the Project Process Gaps:
An Executive Conversation Jim Purcell
Former CTO of Brasfield & Gorrie
ineight.com
Introduction Brasfield & Gorrie • Brasfield & Gorrie will observe its 50th anniversary on June 28, 2014. As one of the nation’s
largest privately held construction firms, Brasfield & Gorrie provides general contracting, design-
build and construction management services for a wide variety of markets, including healthcare,
commercial, institutional, federal, municipal, industrial, infrastructure, and wastewater treatment.
The company is one of the few self-performing general contractors today.
B&G Specs: • 2014 estimated revenue - $2.5B
• ENR Top 400 Contractors Rank - 22
• Headquarters: Birmingham, AL. Regional offices: Atlanta, Raleigh, Nashville, Orlando, Jacksonville, Dallas, Columbus
• Software of note: JD Edwards 9.1, Prolog, P6, Timberline, Hard Dollar, Box, PlanGrid, Jive, Sharepoint
Jim Purcell • CTO at Brasfield & Gorrie since 2002, Partner 2009, employed 1998
• Former president of Construction Information Executives
• Former president of SIM - Alabama Chapter
• Member Oracle EPPM board
ineight.com
Manufacturing vs. Construction Labor-Productivity Declines in the Construction Industry: Causes and Remedies (Another Look)
Paul Teicholz, AECbytes Viewpoint #67 (March 14, 2013)
Professor (Research) Emeritus, Department of Civil and Environmental Engineering, Stanford University
• Coming out of WWII manufacturing and construction had similar productivity levels and efficiency.
• Manufacturing has constantly improved while construction has remained almost flat.
Over the past fifty years, productivity has either slowly declined or remained stagnant. This is in contrast to all
nonfarm industries (which includes construction) which have shown significant increases in labor productivity.”
Causes of Stagnant Labor Productivity in the Construction Industry
• Unique work products built by varying teams under varying site, regulatory and weather conditions
• A procurement system based on competitive rather than collaborative teams
• Poor use of data based largely on paper documents produced by a highly fragmented team
• An economic environment characterized by declining real labor prices
• An industry by many very small firms that perform a significant percentage of the work
• An industry where significant output consists of remodel and renovation of existing facilities as opposed to new work
“
ineight.com
“
Manufacturing vs. Construction
The United States is well behind international best practice in the construction of infrastructure.
While measuring productivity in the construction industry, most observers agree that it has at the very
least stagnated and perhaps even declined over the last three-plus decades. The construction
industry needs to deliver greater value with existing inputs, or even fewer inputs.”
comparison and contrast with construction is helpful for understanding part of what’s happened in the
recent recession and recovery.
In absolute numbers, these two sectors remain the biggest jobs laggards since the recession started.
(Construction has 25 per cent fewer jobs than before the recession, and for manufacturing the number is
13 per cent, according to CreditSights.)
ineight.com
The Way We Did It
• Timberline with Eos Advisor, Explorer and Navigator, Hard Dollar and custom estimating
• P6 for scheduling
• Prolog for cost and document management
• PlanGrid, BIM 360 Field, Latista model, punch list and plan management
• JD Edwards for payroll, cost, financials, billings
• Also Submittal Exchange, Vico, Prolog Mobile / Converge, Bentley Microstation and ProjectWise, eMars, SalesForce,
On Screen Takeoff, Bluebeam, Jive
• Business Objects and SharePoint for reporting and Dashboarding
Project cost
• Estimates rolling from tools to JDE original budget
• Labor, Payroll and Quantities tracked in JDE
• Schedule not integrated
• Costs, Purchasing, Change orders, and all job cost related in Prolog integrated at 23 points using Morpheus
• Owner billings, Accounts Payable, Certified payroll, etc in JDE
The Cost of Chasing Cost
ineight.com
Hard Dollar
Timberline EOS
Tools
AS/400
Original
Budget
JDE
Quantities
Job
Cost -
Actuals
Labor
Prolog
Schedule
Certified
Payroll /
eMars
Billings Accounts
Payable Latista, Bim 360,
Plan Grid
On Screen
Takeoff
ineight.com
Difficulties The costs and sheer effort to maintain systems
• Maintenance costs continue to rise and are 20% of IT budget
Integration costs and management
• Full time employees managing integration plus custom and off the shelf software
Each piece of software has its own upgrade schedule and efforts
Cloud? On Premise?
Storage costs and scalability
• 400% growth in the last 2 years
Joint Ventures
• Whose technology platform do you run on?
Mobility and using iPads for documents, plans and real time collaboration
• End users finding their own solutions like iAuditor and Excel
Schedule and Portfolio management
• No comprehensive portfolio management tied with actuals
Bid Day
• Multiple solutions. Still 40% of work hard bid
ineight.com
What is the Solution?
Integrated solutions – the holy grail of data
Schedule, Crew and Quantities feeding payroll, billing and financials
• Post ERP era according to Gartner. The cost of doing business.
Integration with live plan management
• From conception through as-built into Facilities management
Mobile input and output at all levels
• iPad and similar have made their way into every level of the job site
Time and attendance tracking and cost code management to achieve historic estimating vs. actual
• Estimating to original budget with Warranty and change order estimating at the source all feeding historic
estimating data
• Easier way for Superintendents, Project managers and foreman to use estimated cost codes through construction
for historic cost tracking
- Helps estimating get better
- Shortens the time for conceptual estimates
- Reduces cost of preconstruction
ineight.com
What is the Solution?
Punch list and commissioning integrated
• Give the end users the mobile solution they are finding on their own with a reason to use it
• Safety walks, daily logs, weather logs, noise abatement, dust and particulate tracking
Joint Ventures
• The platform should be usable by all parties
• ideally hosted in the cloud
• license model should support flexible user model without project value as a factor
Dashboards and BI
• Platform for feeding data to BI tools
• BI is a very broad term and is serviced by an entire industry
• Impossible to pick the ultimate tool
• Benefits of data analysis outweigh the cost
All feeding the facilities management of the owners when possible
• Benefits to the owners and operators in reduced cost of loading FM solutions
• Reduced cost of warranty work
• Cost tracking of FM feeding preconstruction to achieve decision analysis about future projects
ineight.com
Innovate Rather than Automate
Unique Work Products Built by Varying Teams under Varying Site, Regulatory and Weather
Conditions
• “There is a need for flexible approaches that minimize risk instead of the most efficient solution for a particular
case.” “…It also leads to resistance to change because the benefits of change may not be realized on the
current project and thus require multiple projects to achieve a payback.”
A Procurement System Based on Competitive Rather Than Collaborative Teams
• “These issues are frequently present on design-bid-build and even design-build projects where some team
members submit bids (typically sub-contractors), the low bidders receive awards and then try to benefit from
extra work.”
• Lock down procurement process that benefits all parties. Cultural hurdle.
• Better use of BIM and IPD
Poor Use of Data Based Largely on Paper Documents Produced by a Highly Fragmented Team
• “Interoperability problems in the capital facilities industry stem from the highly fragmented nature of the industry,
the industry’s continued paperbased business practices, a lack of standardization, and inconsistent technology
adoption among stakeholders.” – National Institute of Standards and Technology Publication Citation NISTGCR
- 04-867 Cost Analysis of Inadequate Interoperability in the U.S. Capital Facilities Industry.
• “However, all stakeholder groups indicated that seamless exchange of electronic data would shorten design
and construction time.”
ineight.com
Innovate Rather than Automate
• “Interviews with participants also included prospective discussions that focused on barriers to information management,
communication, and exchange within the capital facilities supply chain and the opportunities that exist to eliminate these
inefficiencies.”
• “In summary, they view their interoperability costs during the O&M phase as a failure to manage activities upstream in
the design and construction process. Poor communication and maintenance of as-built data, communications failures,
inadequate standardization, and inadequate oversight during each life-cycle phase culminate in downstream costs.”
2004 Study
ineight.com
Innovate Rather than Automate
An Economic Environment Characterized by Declining Real Labor Prices
• “…tends to reduce investment in capital equipment and use of off-site prefabrication which might not be utilized during
a subsequent period of low demand. This reinforces labor-intensive methods, which in turn, puts an emphasis on
reducing costs by reducing training of the labor force and use of the cheapest labor available.”
• A study by Chuck Eastman and Rafael Sacks compared the labor productivity of off-site manufacturing of items used
on construction projects (structural steel fabrication, precast concrete, curtain walls) with similar activities at the
construction site. Using value added per employee, the Economic Census data showed that in all cases, off-site work
is more labor efficient and more capital intensive. - 2008 (“Relative Productivity in the AEC Industries in the United
States for On-site and Off-site Activities.” Journal of Construction Engineering and Management 234[7]: 517-526)
An Industry Characterized by Many Very Small Firms that Perform a Significant Percent of the Work
• “…roughly 62 percent of firms have 5 or fewer employees and generate about 10% of dollar volume. Including the next
three size groups (up to 49 employees) accounts for 96.7% of the firms and 51% of the volume.”
An Industry Where Significant Output Consists of Remodel and Renovation of Existing Facilities as
Opposed to New Work
• “…New Work represents only 65% of total volume, yet this is the segment that receives most attention in research and
trade press. The high proportion of remodeling and upgrading sets the construction industry apart from others, where
only new items are produced.”
ineight.com
Things You Could/Should be Working on
• Wi-Fi on the entire jobsite
• Drones
• RFID / proximity tracking
• Augmented reality
• As-built feeding facilities management
• Internet of things, Smart Connected Real Estate
ineight.com
5 Tech Trends Pushing Enterprises to Meet New Goals – DocuSign Blog, September 5, 2014
Big Data
• “What does that mean to you? Two things. First, there is a tremendous opportunity looming in front of you.
Businesses leveraging Big Data are more than twice as likely to outperform peers and generate double the
profit growth. Second, that you need to prepare your network to meet rising bandwidth requirements.”
Cloud
• “This year, for the first time ever, a majority of workloads will be processed in the cloud. By 2017, 63% will be.”
Mobility
• BYOD offers a variety of benefits to companies, including improved productivity (56%), better customer service
(40%), improved collaboration (35%) and higher employee satisfaction (31%).
Security
• “Cybersecurity is a top concern for enterprises, not just because of the increased amount of devices and
access points, but also the growing sophistication of attacks. The solution is not just enhanced policies and
cloud-based firewall services, but also selecting secure network services with built-in protections ensuring the
safety and accessibility of critical applications and data.”
BC/DR
• “To avoid a fast and painful death at the hands of the downtime monster, businesses must develop a solid
business continuity plan and disaster recovery procedures,”
Things you Could/Should be Working on
ineight.com
Conclusions:
• Industry is ripe for innovation and improvement in productivity. Technology can facilitate.
Need to use integrated solution with reduced cost to run and maintain.
• Owners need to reduce cost to maintain. Comes from upstream lack of integrated information
during the design and build processes.
• Completing the information cycle for repeatable more efficient construction and renovation.
• Innovation drives profits not only in business development but in risk decisions.