CementPal is water based and therefore suitable for indoor use as well

Excellent for exterior protection of driveways, sidewalks, stairs and any brick or masonry that requires protection

SEALER

GLAZE

A high gloss finish for any area that requires protection from the elements or to achieve that “Wet Look” to exposed aggregates, brick, stamped concrete, and masonry.

SEALER GLAZE

A clear non-yellowing penetrating acrylic resin formulated to protect and enhance the appearance of concrete, exposed aggregate driveways, interlocking paving stones, patio slabs, concrete blocks, mortar slate, flagstone, terrazzo and stamped concrete.

CementPal is available in two finishes.

CementPal Sealer is a thin penetrating sealer that seals the concrete pores and provides protection from the elements. The sealer is a good maintenance coating that can be used every year as an on going cleaning and maintenance program.

CementPal Glaze is a higher acrylic content product that has over twice as much acrylic resin and is an excellent value. The Glaze provides a richer gloss and even longer lasting properties.CementPal Glaze provides a rich “Wet Look” appearance to all the above substrates with exceptional abrasion resistance and film flexibility. Clear Concrete Glaze will help strengthen concrete, provide a clean and easy maintenance surface that resists dirt, oils, grease, acids, alkalis, salts. Clear Concrete Glaze is a water based, water shedding seal, which prevents premature aging and spalling of concrete with excellent weathering properties.

Surface must be clean, dry and free of any loose matter or other contaminants. Driveways and patios should be clear of weeds or vegetation. Algae, mold and mildew should be removed using a chlorine bleach solution or WoodPal Quick and Easy Cleaner. Grease or oil, which has penetrated into the substrate, should be removed using a grease spot remover. Any cracks or damaged areas should be repaired and fully cured before coating. Ideally, surfaces should be power washed, but a thorough wash using a pressure tip on a garden hose is acceptable. Before coating, allow the surface to dry.

CAUTION:This new technology is water based and will have a milky appearance in the can and when first applied. When properly applied this milky look turns to a clear, shiny, and tough protective coating.This coating requires specific conditions during application to achieve desired results.

Follow these simple steps for optimum results:Do not apply when the temperature is below 10 degrees C (50 Degrees F ) or greater than 30 degrees C (86 Degrees F ).Do not apply in the direct sun if possible. If it is necessary to apply on a warm day in direct sun slightly dampen the surface to be sealed with a fine spray of water just prior to application.

Do not apply if the weather forecast calls for rain or dew within 8 hours of the expected completion of your project.

APPLICATIONBrush and roller (10 mm (3/8”) pile roller is ideal, an extension pole will make application easier). Air, airless or a low pressure spray such as a

CementPal

Weather WarningCementPal employs the latest water based environmental friendly chemistries. For these products to dry and cure to optimum performance they should be applied when the weather forecast calls for good weather for the next 24 hours after application.