CBM3INSTRUCTION

MANUALTRAVEL GUARD

In the kit provided you will find the following components (fig 1) to be fitted to the section of the buggy (fig 2).

Travel guard.

Fig. 1 Travel guard kit parts

Fig. 2 Travel guard fitted to buggy

Travel guard

Screw driver

Place your bag and buggy on a flat surface and open until the handle is sitting parallel to the ground (fig 3).Note: It is important that the buggy is open in this exact position in order to fit the new travel guard.

It is important to understand that the small protruding edge on the travel guard marked “A” must fit into the opening marked “B” (fig 4).

Fig. 4 Line up travel guard as indicated

Fig. 3 Open handle

Handle parallel to ground, resting on leg.

B

A

Place section A into section B as indicated by arrows and apply pressure with your thumb (fig 5).

While continuing to apply downward pressure with your thumb, using the screwdriver provided, carefully guide section “A” into section “B” (fig 6).

Fig. 5 begin to fit travel guard

Fig. 6 Guide travel guard with screwdriver

Apply pressure

Apply pressure

Fit “A” and “B” together

Guide into “B”

Fig. 7 Fit top of travel guard to buggy

Fig. 8 Travel guard fitted to buggy

Once section “A” has been successfully inserted into section “B” you will be able to complete the fitting process by locking over the top tab of the travel guard (fig 7).

You have now completed the process and the buggy should look like this (fig 8).

Top tab locked over buggy

To see the CBM3 in action visit concoursegolf.com