Body Electrical

1

Body Electrical- Lighting- Meter- Air Conditioner- Toyota Parking Assist- Power Window- Wireless Door Lock Control- Engine Immobiliser- Theft Deterrent System- SRS Airbag

2

Body ElectricalLighting

• Head Lamp projector for Low Beam

High BeamLow Beam

(with projector)

Turn Signal

Reference construction

3


• Front fog lamp, side turn signal & rear combination lamp

Combination Lamp

Front Fog Lamp

Side Turn Signal

4

Body ElectricalService Points

• Replacing side turn signal bulb

Outer rear view mirror and Outer mirror cover must be removed to replace the turn signal bulb.

5


• High Mount Stop Lamp, LED type (S grade) & Bulb type (G grade)

1.5 S

1.5 G

6

Body ElectricalMeter

• Analog type combination meter

7

Body ElectricalMeter

• LCD Fuel meter

The low fuel level warning light blinks when fuel is less than 6.8L in the tank.(Tank capacity is 45L)

8

Body ElectricalAir Conditioner

• Manual Air Conditioner• Double Blower

Rear blower (A/C) will operate if ONLY front A/C is operated

9

Body ElectricalTOYOTA Parking Assist

• Standard equipment in all models

”A” distance (mm) Indicator Buzzer

Approx. 1500-1150 (59.1-45.3) Blinks Intermittent

Approx.1150-800 (45.3-31.5) Fast Blinks Fast Intermittent

Approx 800 (31.5) or less Lit Continuous

Sensors

Click Movie

10

Body ElectricalPower Window

• Standard equipment in all models• One touch auto-up/down for driver’s door

Window Lock

Notes: WITHOUT Jam Protection function

11

Body ElectricalWireless Door Lock

• Standard equipment in all models

Lock - Unlock !

UnlockLock

12

Body ElectricalService Points

• Wireless Code Registration Procedure

* Up to 4 transmitters can be registered. (part no. 89742-BZ050)

1. Prepare all transmitters to be registered2. Confirm no key in the ignition key cylinder3. Disconnect the battery negative terminal or door control receiver connector4. Reconnect the battery negative terminal or door control receiver connector5. Within 15 seconds, close all doors and press the unlock switch of 1st

transmitter for 5 seconds or more6. Confirm that the door control receiver automatically performs the lock-

unlock operation once7. Within 5 seconds, press the lock switch for 1 seconds or more8. Confirm that the door control receiver automatically performs the lock-

unlock operation once9. Repeat step 5 (excludes closing all doors) to step 8 to register other

transmitters10. Wait for 15 seconds or more after registration of all transmitters

13

Body ElectricalEngine Immobiliser System

• Disables the engine from starting using the ignition key without an ID code that matches the pre-registered code in the vehicle

• Standard equipment for all models

Transponder Chip

Transponder Key Coil

ID Code

Transponder Key ECU

Matching

Click Movie!

14

Body ElectricalEngine Immobiliser System

• System Diagram

15

Body ElectricalTheft Deterrent System

• Standard equipment in all models• TDS system is equipped in TAM (Port Installation Option)

System Indicator (w/ Immob System)

16


• Maximum of 4 transmitter can be registered• Transmitter for this system is different from Door Lock

Transmitter (factory original)

Lock Button

Un-Lock Button

Panic Button

Indicator

1. 2 transmitter are provided (total 3 pcs, including factory original)

2. Can be used for LOCKING/UNLOCKING

Factory Original

Spare Tire Cover Key

17


• System operation

18

Body ElectricalRegistration (Alarm Transmitter)

1. Prepare transmitter to be registered2. Driver’s door: start from open condition, close and open door once in less than 5

seconds.3. Insert IGN key, turn to ON then ACC for 5 times (last position is ACC), then after 1.5

second, horn will sounds once.4. Press transmitter button:

a) LOCK 5 times* for the 1st transmitter, while pressing the button, horn will sound once, to indicate that registration memory has been added.

b) LOCK 1 time for 2nd transmitter, while pressing the button, horn will sound once, to indicate that registration memory has been added.

5. Programming will be completed if:a) 10 seconds has elapsed (no activities)b) IGN Switch is turn to ON positionc) Close and open any of the door (s)

6. Horn will sound once (short) then another once (long), to indicate that the programming has been completed

*: If the transmitter is lost, while no replacement at the moment, by only doing step (a) will automatically erasing registered transmitter from ECU

19

Body ElectricalSRS Airbag

• Standard equipment for 1.5 S A/T model• Electronic type Airbag for Driver and front passenger

20

Documents

Body Electrical