7/27/2019 Blood Electrification Protocol

http://slidepdf.com/reader/full/blood-electrification-protocol 1/4

Blood Electrification Protocol

Introduction 

The first creation by the hands of Dr. Beck after his acclaimed brain tuner is a device known as a bloodelectrifier that facilitates the process of blood electrification. The creation of the blood electrifier is directlyassociated with the following patent that seems to have been suppressed well enough at the time andwas not supported as a mainstream or applied therapy.

The original patented research intended that the microcurrents be applied to the blood while it circulatedoutside of the body or treated through the installation of an implanted device in the arm.

Experiments were conducted by the doctors that  proved : Applying a low level of electricity (50 to 100 μAmicroamperes) could be used to effectively disable or attenuate bacteria, viruses, parasites and/or fungusso that they may not attach to, or enter the cells - without affecting the biological state of healthy cells,blood, and other bodily fluids. Blood electrification is scientifically proven to produce these results. 

This process, of applying pulsed microcurrents causes the blood and tissue cell membranes to oscillate(vibrate), the cell membrane opens and closes rapidly (a process known scientifically as electroporation),flushing the serum in and out, taking with it microorganisms which would otherwise be using the cellinterior for its store of nutritional reserves and as an environment in which to replicate or develop intomore advanced phases.

The blood, being the major component of our circulatory systems - carries oxygen from our lungs andnumerous nutrients and chemicals from our food and environment throughout the body - it is the mostbasic and important bodily fluid effecting our bodies status. By being able to perform this procedure wegain the ability to drastically improve our state of health, quickly and reliably, not only this, but also thesimplicity and advantage of maintaining that state of health with regularity of use.

Dr. Beck’s specifications for the units output is designed to deliver between 50 to 100 μA to the blood ascalled for in the research while wearing electrodes contacting the skin, secured over the wrists or ankles -in a noninvasive format . This allows the unit to be applied within your own comfort zones, either at home,at work or elsewhere in a simple manner.

Application 

First be sure you are using a set of fresh 9 volt alkaline batteries, I personally recommend therechargeable varieties, as well as a handy battery tester for good measure. Purchasing batteries could bea needless expense if you are insisting on using the device for a very long term. At a rate of two hours of daily use you can expect to be replacing all three batteries simultaneously about every four to five daysfor maximum benefits in microcurrent delivery. This can be deduced either from not feeling th currents'tell-tale' sensation or a dimmed/non-existant indicator LED.

If you are concerned with the level of electricity emmited by the device, you can rest assured in knowingthat the microcurrent output is measured in milli-amps which is an extremely safe power level, and isused widely in the areas of electronic therapies. One ampere is equivalent to 1000 milliamperes. Here you can see a chart of common appliances and their average amperage ratings. The electrifiers output isvery low in comparison to these and is very safe for its intended application. I have not discovered anyissues with this aspect of the unit in regards to electrical safety. Again, the power is supplied solely fromthe three 9 volt batteries, totaling 27 volts in discharge.

 After battery installation is complete, the electrodes are inserted into the input jack of the device, the unitis left off or turned off and then the location of your pulse points need to be determined. This will coincidewith the positioning of the electrodes, wrist strap adjustment and application of electrolyte gel. The mostcommon and convenient location is upon the forearm/wrist ulnar and radial pulse points, but they can alsobe applied to the ankle pulse point locations if you wish to do so. The microcurrents generated by thedevice then has the ability to to get far enough beneath the tissues into the blood flow driving the pulse.

For blood electrification, the electrodes must be placed accurately in order for the electricity to penetratethe arteries. Specifically, the electrifier end-points are placed upon ones ulnar and radial pulse points, asshown:

7/27/2019 Blood Electrification Protocol

http://slidepdf.com/reader/full/blood-electrification-protocol 2/4

 

Once located, using an alcohol swab or cleaning the area with soapy water is recommended as it helps togreatly improve skin contact and conductivity with the electrodes by removing dead skin cells, dirt andresidue/oils or debris that could possibly resist the currents penetration into the skin. Placement of theelectrodes is then secured onto these locations with the adjustment of a wrist strap to a comfortable buttight fit to keep them nominally and securely contacting the skin. After this, an application of electrolytegel is placed on and around the site of the electrodes beneath the strap, being aware of not spreading thesolution in between the points as the current must reach a penetrating depth before dissipating.

Following this, the unit can then be switched on, and the devices effects will begin immediately - alwaysstart the unit at the minimum setting of the adjustment knob to avoid sudden shocks, it doesn't hurt butcan be slightly uncomfortable when starting a session. You can then increase the amplification until acomfortable level is attained for your level of sensitivity, which will usually adapt after beginning regular usage of the blood electrifier. When that point is achieved, an increase in power is recommended to reset

the sensation. At higher settings there is a tendency for ones hand and fingers to pulsate slightly.

Guidelines 

It is best for new users to begin the therapy with a gradual increase in the application of session times.The optimal rate of treatment is 2 hours a day for a length of 4 weeks. What is suggested is a gradualbuild-up of 15 minute increments per day until a 2 hours daily mark is reached and sustained.

Session times:

The process would look like this as a basic treatment schedule:  Day 1: On the first day of the treatment a 15 minute initial session is inititated.Day 2: From here on an increase of 15 minutes longer per day is attained for a total of 30 minutes.

Day 3: Increased to 45 minutes.Day 4: Increased to 60 minutes (1 hour)Day 5: Increased to 75 minutes (1 hour 15 minutes)Day 6: Building up further to 90 minutes (1 and 1/2 hours)Day 7: Increasing to 105 minutesDay 8: Finally, the 120 minuted mark for a total of 2 hours on this day.

From then on, the weekly count begins and weeks 1, 2, 3 and 4 persist at a 2 hour daily regimen.  

For a schedule printout to assist with following these guidelines click here. (PDF )

7/27/2019 Blood Electrification Protocol

http://slidepdf.com/reader/full/blood-electrification-protocol 3/4

 After the four weeks it is also a good procedure to gradually decrease the session time in the same wayit was built-up to in 15 minute increments deducted per day to let systems 'down easily'. Any immediatechanges to the body can cause discomfort or disturbance so in doing this we help to get the bodiesreactions to return to 'normal' safely and with stability.

 Although this a 'by the books' method of application, there is nothing wrong with intermittent or maintenance treatments a few times a week. The reason that the duration of 2 hours daily holds

importance is due to the recirculation time of blood in the body. It takes about 8 to 10 minutes for theentire contents of the circulatory system to circle back around to the application pulse points.

Therefore, roughly twelves cycles can be completed successfully in that 2 hour time frame. This too is asomewhat flexible guideline, but it is a good idea to stay within that vicinity of maximum time for practical purposes and stable acclimation of the bodily and excretory systems.

Hydration 

During the course of treatments it is highly recommended to drink a daily minimum of water (preferablyozonated), including a portion of that daily amount both - just before and just after the treatmentsessions for improvement in both collective elimination and hydration to help with the dispersion of cellular debris that will be released by the cells, as well as the neutralized microbe loads that begin tobe introduced in higher than normal concentrations in the body.

 A standard amount to focus on drinking daily is a minimum of what you could calculate as:half of ones total body weight into ounces of water .

For example: weighing at 140 pounds would suggest aminimum amount of 70 ounces of water for the day.

This is one of the more strict precautions one should followand even surpass, your body will need as much help as it canget, particularly in its elimination aspect during this time.

If you are well hydrated prior to the treatment, your cells willbe able to conduct the microcurrents more efficiently as well.This will enhance your treatment experience and will also helpwith the removal of wastes and toxins, which will most likely

be a side effect of treatment.

Drinking hydrating fluids throughout the days and timesbetween sessions also tends to dramatically decrease theduration of what could feel as a relative period of weakness or irritability due to an increased number of pathogenic "die-off",medically termed: herxheimer reactions.

Elimination 

 Aside from staying well hydrated, the use of physical activities to stimulate the circulation by getting theblood pumping and elimination by sweating (which seems to be easily forgotten of its importance inkeeping us 'clean') is an extremely good habit. This can be accomplished in a number of ways withoutsimultaneously causing too much strain on the body, which is also something one may need to consider during their therapy. You can even participate in numerous activities while donning the device if the idea

suits you, allowing you to keep track of your treatment time and improving focus on your health relatedgoals.

Low impact sports such as rebounding, bicycle riding, brisk outdoor walks, stationary cycling, ellipticalexercises and even dancing are possibilities that work well. A daily routine with the therapy is definitelyadvisable to help one be more engaged in the total impact upon improving their state of being andpersonal health. I personally discovered the interesting benefit of dramatically increased endurancewhile beginning to use the device during my daily bicycle trips. Surprising to me at the time was theability to withstand cold and violent weather much more easily than I previously could (sometimescatching a cold or fever in the process). Even more amazing is that with this ability came an almost

7/27/2019 Blood Electrification Protocol

http://slidepdf.com/reader/full/blood-electrification-protocol 4/4

unbounding amount of energy that could allow me to cycle much faster, further and for much longer durations.

Diet & Supplementation 

In accordance with the therapy there are a few important precautions to follow for the safest and best

resultant outcome of each treatment session.

For example, Dr. Beck suggested in his workshops to take any essential medications shortly after asession (generally 15 minutes or more) and then wait 20 - 24 hours before the next session to givetime for what was ingested to reach lower concentrations in the blood. Its a good idea to disallow anyitems that you wouldn't want to accidentally overload your body with at least two days before beginningany of the electronic parts of the protocol.

This is due to the effect of electroporation that the microcurrents produce upon the blood cells - allowingthem to absorb and release more of what is ingested and metabolised from within the body. For thisreason, Dr. Beck issues a warning to avoid the use of caffeine, prescription drugs, alcohol, and nicotinewhen using the electronics of the protocol. From food to drugs and cigarette smoke, it is generally agood thing to follow through with some fresh, wholesome foods and supplements throughout the term of the application.It is also wise to ensure that vitamin and mineral supplements are from as complete and natural sources

as possible ( i.e., organic).

Understanding what electroporation is and does helps to explain why these guidelines exist and why theeffects from the therapy take place. Electroporation goes hand-in-hand with microcurrent therapyapplications to the body and is somewhat a double-edged sword in the way it improves bodilyprocesses.

Electroporation ( please read ) occurs when microcurrents are applied to the body— cell walls becomemore permeable allowing nutrients to pass in and out more readily, up to 20 to 30 times more of what isin the contents of the blood plasma during electrification.

This is a plus, of course, when beneficial nutrients are present in the blood stream. On the other hand, itcan be a threat if potentially toxic substances are circulating in the blood. The initial concern is, whatyou consume within the time frame of a day before beginning a session.

I personally have not had such adverse effects during my personal experience and course of applyingthis therapy, but, I believe that this is a matter of some experimentation on your behalf, but the definateavoidances should be prescription drugs (this is very important to avoid, especially strong, side-effectinducing drugs), as well as potentially harmful substances such as nicotine, alcohol, recreational drugs, pain killers, blood thinners, and garlic (Dr. Beck makes special mention of the toxicity that garlic has,including the potential of crossing the blood-brain barrier).

It is also important to note: Pregnant woman, and those using with pacemakers should avoid any of these electronic therapies as asafety precaution.