Baryon-to-meson production in a wide range o f baryo-chemical potential at R H IC

Baryon-to-meson production in a wide rangeof baryo-chemical potential at RHIC

Paweł Staszel, Marian Smoluchowski Institute of Physics

Jagiellonian University

Quark Matter 2009 Knoxville, 30.03–4.04.2009

2P. Staszel - Jagiellonian University, KrakówQM 2009, Knoxville 2009

BRAHMS 2

Outline1. Introduction

2. BRAHMS experimental setup

3. Data analysis on p/p ratios

4. Results: a) Au+Au and p+p at 200 GeV b) Au+Au: 200 GeV versus 62 GeV c) Au+Au and p+p at 62 GeV and forward rapidity

5. Summary


BRAHMS 3

IntroductionHigh baryon to meson ratio at intermediate p

T (~1)

discovered at RHIC in Au+Au reactions (Adcox PHENIX) was inconsistent with pQCD predictions

It was pointed out that baryon to meson ration pT

dependence should be sensitive to: hadronization scenario baryon: 3 valence qarks, meson: quark – anti quark

radial flow of bulk medium proton mass > pion mass

Energy and centrality depencence of p/p+ and pbar/p- and their evolution on rapidity may allow to verify the

proposed scenarious

A bit of history

Quark coalescence can explain large mid-rapidity pbar/p- ratio at intermediate p

T range

when allow mini-jet partons to coalescence with QGP (thermal) partons(V. Greco, C.M. Ko, and P. Levai, PRL90 (2003)

022302)

PHENIX

Hydro model overpredicts mid-rapidity p/p+ ratio at low p

T (<2 GeV/c) and underpredicts at

pT>2.5.

Reasonable description by quark coalescence model (E.J. Kim, et al., Nucl. Phys. A 774 (2006) 493)


BRAHMS

Strong rapiditydependence

CuCu data consistent with AuAu for the same Npart

pp

pp

pbar/p- scaling with Npart

sNN=200GeV

6

BBroad RaRange HHadron MMagnetic SSpectrometers

Tile Ring 1

Flow Ring 2

Si Ring 1


BRAHMS 7

Data Analysis

protons

Same acceptance for pions and protons in the real time measurements. For given h-p

T bin p/p ratio is calculated on setting by setting basis using same pid

technique:Tof2: 2.3->~8GeV/c, RICH: above 9 GeV/c, thus acceptance corrections, tracking efficiency and trigger normalization factors cancel out in the ratio.Remaining corrections:i) decay in flight, interaction in the beam pipe and detector material (GEANT calculation)ii) correction for PID: pion contamination in Tof2 and RICH (limited mass2 resolution)

veto-proton contamination by pions and kaons (RICH efficiency < 1)

pions


BRAHMS 9

Data Analysis: Tof2 and RICH Pid


BRAHMS 10

Results


BRAHMS 11

Au+Au and p+p at 200 GeV

positive negative


BRAHMS 12

Results: p+p at 200 GeV versus rapidity

Strong rapidity dependence at intermediate p

T

At hight pT ratios seem to

converge to common value of ~0.4 → consistent with pQCD predictions

Results: Au+Au and p+p at 200 GeV at low p

T

Negative: at low pT (<0.5GeV/c)

p+p > 40-80% > 0-10% , crossing point at ~0.9 GeV/c. How sensitive are models in this p

T range

(hydro versus quark coalescence scenario ?)


BRAHMS 14

AMPT (A Multi-Phase Parton Transport model) Z. Lin, PRC 72 (2005) 064901

Au+Au and p+p at 200 GeV at low p

T

THERMINATOR: under predicts data at mid-rapidity, but good description at forward rapidities (particularly for pbar/p-) B. Biedroń and W. Broniowski, PRC 75, 054905 (2007)

AMPT: qualitatively describes trends in rapidity evolution but fails in quantitative description (in general AMPT under predicts p/p+ and over predicts pbar/p-)

Central Au+Au at 200GeV: p/p rapidity evolution – comparison with models


BRAHMS 16

p/p rapidity evolution – AMPT: string fragmentation versus string melting


BRAHMS 17

Au+Au: 200 GeV, h=2,2 versus 62 GeV, h=0


BRAHMS 18

Au+Au and p+p at 62 GeV at forward rapidity

Quark recombination incorporating parton momentum degradation and sea quark regeneration.Degradation parameterk ≅from fit to data

R. Hwa and L. Zhu, PRC 78, (2008) 024907

SummaryWe presented results on p/ p (p

T) ratio versus rapidity and collision centrality for Au+Au

at 200 and 62.4 GeV and for p+p at 200 GeV

1) weak dependency on collision centrality at low pT up to ~1.5GeV/c. Below p

T ~0.8GeV/c the

pbar/p- ratios for p+p are larger that these measured in Au+Au.

2) the dependency on centrality (as documented by Npart

scaling) reveals above pT>1.5GeV

3) For central Au+Au at 200 GeV p/ p + shows increasing trend with increasing rapidity from 1.0 (h~0, p

T=3 GeV/c) to about 2.5 (h~3, p

T=3 GeV/c). In opposite, pbar/ p - decreases with

increasing rapidity (from ~1 at h~0 to 0.4 at h~3).

4) The p/ p ratios are remarkably similar for √sNN

=200 GeV at h=2.2, and for √sNN

=62.4 GeV at

h=0, where the bulk medium is characterized by the same value pbar/p-

5) For Au+Au and p+p at √sNN

=62.4 GeV the astounding value of p/p is observed (~8 at

pT=1.5GeV/c). Au+Au consistent with p+p → no evidence for system size dependency in the

covered pT range.

Data comparison with models:

The THERMINATOR model provides reasonable quantitative description of the data except for p

T>3 GeV/c and mid-rapidity where it under predicts the ratios. AMPT(default) provides

qualitative description of the trends in rapidity evolution but can not describe dependency on centrality including p+p results. AMPT (string melting) is far from data particularly regarding the pbar/p- ratios


BRAHMS 20

I.Arsene7, I.G. Bearden6, D. Beavis1, S. Bekele6 , C. Besliu9, B. Budick5, H. Bøggild6 , C. Chasman1, C. H. Christensen6, P. Christiansen6, R. Clarke9, R.Debbe1,

J. J. Gaardhøje6, K. Hagel7, H. Ito10, A. Jipa9, J. I. Jordre9, F. Jundt2, E.B. Johnson10, C.E.Jørgensen6, R. Karabowicz3, N. Katryńska3, E. J. Kim4, T.M.Larsen11, J. H. Lee1,

Y. K. Lee4, S.Lindal11, G. Løvhøjden2, Z. Majka3, M. Murray10, J. Natowitz7, B.S.Nielsen6, D. Ouerdane6, R.Planeta3, F. Rami2, C. Ristea6, O. Ristea9, D. Röhrich8, B. H. Samset11, D. Sandberg6, S. J. Sanders10, R.A.Sheetz1, P. Staszel3, T.S. Tveter11, F.Videbæk1, R. Wada7, H. Yang6, Z. Yin8, and I. S. Zgura9

1Brookhaven National Laboratory, USA, 2IReS and Université Louis Pasteur, Strasbourg, France3Jagiellonian University, Kraków, Poland,

4Johns Hopkins University, Baltimore, USA, 5New York University, USA6Niels Bohr Institute, University of Copenhagen, Denmark

7Texas A&M University, College Station. USA, 8University of Bergen, Norway 9University of Bucharest, Romania, 10University of Kansas, Lawrence,USA

11 University of Oslo Norway

48 physicists from 11 institutions

The BRAHMS Collaboration


BRAHMS 21

BACKUP SLIDES

pionsprotons

Same acceptance for pions and protons in the real time measurements. For given h-p

T bin p/p ratio is

calculated on setting by setting basis using same pid technique:Tof2: 2.3->~8GeV/c, RICH: above 9 GeV/c, thus acceptance corrections, tracking efficiency trigger normalization canceled out in the ratio.Remaining corrections:i) decay in flight, interaction in beam pipe and material budged (GEANT calculation)ii) correction for PID efficiency and contamination (limited specie resolution)

Data Analysis: RICH inefficiency

1. ineffic = veto/all2. Additional control of specie dependence by comparing A (less protons) and B (more protons) polarities:

High field runs Low field runs

3. observed dependency on T5 x-slope, similar to that encountered at low field runs

1. Identify pions with no RICH ring (RICH veto pions) in tof2.ineffic = veto pions / all pions 2. two relevant dependencies are found: a) dependency on p/p

th (Cherenkov threshold effect)

b) dependency on track x-slope (geometrical effect)

3. For fields like 608 and 861 p/pth>>1 and

geometrical effect can be studied alone. Then in can be use to disentangle Cherenkov threshold effect for lower field run (430) where both effect play a role.

Test of corrections for veto-protons


BRAHMS 25

Data Analysis – related systematic uncertainties

At mid-rapidity an overall systematic error is 5%

Usual inefficiency formula Ordinary exponent with build-in matching to low p/p

th

RICH inefficiency scaling with p/pth


BRAHMS

K-/K+ and antihyperon/hyperon

K-/K+ = exp((2s - 2u,d)/T)pbar/p = exp(-6mu,d/T)ms=0 K-/K+ = (pbar/p)1/3

Fit shows that K-/K+ = (pbar/p)1/4

s= ¼ u,d

How ms= ¼ mu,d will work for hyperons?Hbar/H = (pbar/p)3/4 for L = (pbar/p)1/2 for X = (pbar/p)1/4 for W


BRAHMS

Statistical model and s vserus u,d

Fits with statistical model provide similar u,d/ms ratio

with weak dependency on y.

This result is consistent with local net-strangeness conservation red line - s = 0black line – fit to BRAHMS data

B. Bieron and W. Broniowski Phys. Rev. C75 (2007) 054905

Documents

Baryon-to-meson production in a wide range o f baryo-chemical potential at R H IC