Upload
others
View
4
Download
0
Embed Size (px)
Citation preview
Instruction Manual
REV 05/20/16
WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failureto follow the safety rules and other basic safety precautions may result in serious personal injury.Save these instructions in a safe place and on hand so that they can be read when required. Keep these instructions to assist in future servicing.
Air Operated Waste Oil Drainer
GENERAL SAFETY REGULATIONSWARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions or situations that could occur. It must be understood by the operator that common sense and caution are factors that cannot be built into this product, but must be supplied by the operator.
1. Keep the work area clean and dry. Damp or wet work areas can result in injury.
2. Keep children away from work area. Do not allow children to handle this product.
3. Use the right tool for the job. Do not attempt to force small equipment to do the work of larger industrial equipment. There are certain applications for which this equipment was designed. It will do the job better and more safely at the capacity for which it was intended. Do not modify this equipment, and do not use this equipment for a purpose for which it Was not intended.
4. Check for damaged parts. Before using this product, carefully check that it will operate properly and perform its intended function. Check for damaged parts and any other conditions that may affect the operation of this product. Replace damaged or worn parts immediately.
5. Do not overreach. Keep proper footing and balance at all times to prevent tripping, falling, back injury, etc.
6. DO NOT use the equipment when tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating this equipment may result in serious personal injury
E1
TEC
HN
ICA
LD
ETA
ILS
SAFE
TYPR
ECA
UTI
ON
SA
SSEM
BLY
OPE
RA
TIO
NLI
MIT
EDW
AR
RA
NTY
EXPL
OD
ED A
ND
PAR
TS L
IST
Item No.Air InletCapacityMax Draining PressureDraining Hose LengthCollection Bowl Capacity Extension Funnel Diameter
16211506G1/4"30Gal/115L14.5PSI/1Bar63"/1600mm4.8Gal/18L23.8"/606mm
TECHNICAL DETAILS
SAFETY PRECAUTIONS
• Do not extract caustic or flammable products• Do not expose the reservoir to any source of heat• While extracting high temperature oils, keep hands and face protected • Only use the device for the purpose for which it has been designed• Do not modify any component of the equipment• Only use original spare parts• Our technical office is at you full disposal for any information you may need
• Never fill the reservoir over the maximum level indicated by the gauge that is located on the side of the reservoir.
• Don’t exceed maximum pressure 1bar/14.5psi for draining.• Open the bottom nut of the reservoir termly and clean out any dirty to avoid
jam.
H(closed) H(open)P(closed)P(open)
I(closed) I(open)
E2
TEC
HN
ICA
LD
ETA
ILS
SAFE
TYPR
ECA
UTI
ON
SA
SSEM
BLY
OPE
RA
TIO
NLI
MIT
EDW
AR
RA
NTY
EXPL
OD
ED A
ND
PAR
TS L
IST
ASSEMBLY
E3
TEC
HN
ICA
LD
ETA
ILS
SAFE
TYPR
ECA
UTI
ON
SA
SSEM
BLY
OPE
RA
TIO
NLI
MIT
EDW
AR
RA
NTY
EXPL
OD
ED A
ND
PAR
TS L
IST
P(Open)
Fig.5: Place the oil drainer under the car to collect the waste oil.
Fig.1: Insert the tube(N) into the reservoir, then turn the handwheel(O) clockwise direction and tighten.
Fig.2: Assemble the handle(B) and the air inlet fitting, turn off the ball valve(H).
NO B
H
C
Fig.3: Assemble the rotor tube, ball valve (P), collecting bowl, filtrating plate and extension funnel orderly.
P(Open)
OPERATIONCOLLECTING
Fig.4: Close all of the valves. Turn on the valve(H) and the valve(P) .
I(Close)
H(Open)
E4
TEC
HN
ICA
LD
ETA
ILS
SAFE
TYPR
ECA
UTI
ON
SA
SSEM
BLY
OPE
RA
TIO
NLI
MIT
EDW
AR
RA
NTY
EXPL
OD
ED A
ND
PAR
TS L
IST
1 bar
Fig.6: Close all of the valves, put the spout (M) into the waste oil tank, then open the valve (I).
Fig. 7: Connect the air supply.
Fig.8: Open the valve (H) for draining.
M
P(Close)
H(Close)
I(Open)
H(Open)
DRAINING
LIMITED WARRANTY• The manufacturer warrantees this product against defects in material and craftsmanship, for a
period of one year from date of purchase, but not including wearing parts. • Manufacturer’s liability is limited to replacement or repair of defective material within the
warranty period. • The warranty does not cover damage caused by accident, misuse or faulty installation. • The product must be installed and maintained in compliance with the instructions.
E5
TEC
HN
ICA
LD
ETA
ILS
SAFE
TYPR
ECA
UTI
ON
SA
SSEM
BLY
OPE
RA
TIO
NLI
MIT
EDW
AR
RA
NTY
EXPL
OD
ED A
ND
PAR
TS L
IST
1
2
3
4
5
6
Part No.123*4*5*6
DescriptionOil collecting bowl assemblyReservoirSafety valveDischarging hose assemblyBall valveQuick plug
Q'ty111111
#:Optional accessories *:Wearing parts
EXPLODED & PART LIST
E6
TEC
HN
ICA
LD
ETA
ILS
SAFE
TYPR
ECA
UTI
ON
SA
SSEM
BLY
OPE
RA
TIO
NLI
MIT
EDW
AR
RA
NTY
EXPL
OD
ED A
ND
PAR
TS L
IST
1-1
1-2
1-3
1-4
1-5
1-8
1-9
1-5
1-11
1-12
1-13
1-14
1-7
1-6
1-10
Part No.1-11-2*1-31-4*1-51-61-7
DescriptionCheck nutCompression springO-ring Sealing bushO-ring Expansion coverHandwheel
Q'ty1121411
Part No.1-8*1-91-101-111-121-13#1-14
DescriptionSupporting tubeBall valveNutRetainer sleeveOil collecting bowlFiltrating plankExtention funnel
Q'ty1111111
#:Optional accessories *:Wearing parts
OIL COLLECTING BOWL ASSEMBLY & PART LIST
E7
TEC
HN
ICA
LD
ETA
ILS
SAFE
TYPR
ECA
UTI
ON
SA
SSEM
BLY
OPE
RA
TIO
NLI
MIT
EDW
AR
RA
NTY
EXPL
OD
ED A
ND
PAR
TS L
IST
Part No.2-12-22-3*2-4*2-5*2-6*2-72-8*2-92-10
DescriptionHandleU-type hook ScrewButterfly valveSwivel fittingNutsSpring washerGasketCaster Bolts
Q'ty1131122222
Part No.*2-112-122-132-142-152-162-172-182-192-20
DescriptionWheelReservoir assemblyBoltO-ringScale coverScale tubeBushing90°connectorClipGasket
Q'ty2111111211
#:Optional accessories *:Wearing parts
2-4
2-5
2-6
2-7
2-8
2-92-102-112-12
2-15
2-16
2-17
2-18
2-13
2-14
2-19 2-1
2-2
2-3
2-20
RESERVOIR & PART LIST
Goodyear (and winged foot design) and Blimp are trademarks of The Goodyear Tire & Rubber Company used under license by Intradin (Shanghai) Machinery Co., Ltd. China.
Copyright 2016 The Goodyear Tire & Rubber Company.
Size: 145x210mm REV 05/20/16 3.02.01.140157克铜版纸