79-fc141

Embed Size (px)

Citation preview

  • 7/24/2019 79-fc141

    1/2

    2008 Cummins Inc. Box 3005 Columbus IN 47202-3005 U.S.A.

    Printed from QuickServe

    Online.

    All Rights Reserved. Last Modified: 02-Mar-2011

    File: 79-fc141 Page 1 of 2

    Fault Code 141

    Oil Pressure Sensor Circuit

    CODES REASON EFFECT

    Fault Code: 141PID(P), SID(S): P100

    SPN: 100FMI: 4Lamp: YellowSRT: 00-087

    Low voltage detected at oilpressure sensor signal pin 7 of the

    sensor harness connector.

    No engine protection for oil pressure.

    Oil Pressure Sensor Circuit

    Circuit Description:

    The oil pressure sensor is used by the electronic control module (ECM) to monitor the lubricating oil pressure. The ECMmonitors the voltage on the signal pin and converts this to a pressure value. The oil pressure value is used by the ECMfor the engine protection system.

    Component Location:

    M11 - The oil pressure sensor is located on the engine block to the right of the ECM.

    N14 - The oil pressure sensor is located on the engine block near the pan rail on the fuel pump side of the engine.

    Shop Talk:

    If Fault Code 143 or 415 is notpresent, the problem is notbase engine related.

    Refer to Troubleshooting Fault Code t05-141

  • 7/24/2019 79-fc141

    2/2

    2008 Cummins Inc. Box 3005 Columbus IN 47202-3005 U.S.A.

    Printed from QuickServe

    Online.

    All Rights Reserved. Last Modified: 02-Mar-2011

    File: 79-fc141 Page 2 of 2