SHFUSB10

Congratulations on the purchase of your new SandstrØm 100 Watts Hi-Fi Component System.

Please follow this quick start guide for a successful first time set up.

We recommend that you spend some time reading the instruction manual in order to fully understand all the operational features it offers.

Read all the safety instructions carefully before use and keep the instruction manual for future reference.

You will find that there are many exciting features available.

To get to know all these features, please take some time to read the instruction manual provided.

Quick Start Guide

1 Unpacking 2 Battery

3 Connections

4 Clock Setting 5 Basic Operation

Tip:

100 Watts Hi-Fi Component System

Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so according to any local regulations.

CD Player Speakers x 2 Remote Control

Amplifier

Base

Instruction Manual

Speaker Cable x 2

(P.N.: SHFUSB10P0006)

Remove the insulating mylar strip from the battery if the battery is being used for the first time. It is located at the bottom back side of the remote control.

Setting the Clock Automatically

Tune into a RDS station and wait for a few minutes. The clock will be automatically set.

To view the time, press the CLOCK button.

Setting the Clock Manually

In standby mode, press the CLOCK button twice, SET CLOCK will be displayed and the hour indicator will flash.

Set the hour with the VOL + / – button.

Press the CLOCK button, minute indicator will then flash.

Set the minute with the VOL + / – button.

Press the CLOCK button to confirm. The clock is now set.

1.

3.

4.

5.

2.

Battery Installation for the Remote Control

1. Unwind the screw and slide open the battery compartment of the remote control.

FM Aerial x 1 Control Cable x 1

Quick Start Guide

2. Remove the old battery, and place a new battery (CR2025 Lithium Battery) in the holder.

3. Close the battery compartment cover and wind the screw back on.

Right Speaker Box

The Amplifier

The CD Player

Left Speaker Box

Connecting the FM AerialConnecting the

Control Cable

Connecting to the Mains Supply Speaker Connections

Back View

1

Connecting the FM Aerial

Connect the FM wire aerial provided to the FM Aerial socket as illustrated below.

1

Speaker Connections

Connect the speaker cables at the back of the speakers to the speaker sockets (L/R) at the rear side of the amplifier.

2

Connecting the Control Cable

Connect the control cable between the CD player and the amplifier.

3

Connecting to the Mains Supply

Insert the mains plug into a wall socket, and your system is ready to use.

4

3

4

22

2

Please ensure mains cable is DISCONNECTED from the mains socket before connecting any cables.

• Reversing the steps by connecting the mains cable first may cause the unit to malfunction.

• During operation if the cables / wires require to be reconnected, the mains must be disconnected first. Otherwise damage may be caused to the unit .

Selecting Modes

Press the FUNCTION button repeatedly to select CD, USB, AUX or TUNER mode.

CD USB

AUXTUNER

Switching the unit On

Press the STANDBY button at the front or on the remote control to switch the unit on.

You can also press the short-cut buttons on the remote control ( , , , ) to select your desired mode.