Finalize cadet image on 2D Design. Summarize important points for using 2D Design Observe set up...
16
Finalize cadet image on 2D Design. Summarize important points for using 2D Design Observe set up and running of the laser cutter. Compare the quality of the laser cutter to the Roland MDX-40. 2D Design Support 1. Use the path tool to draw around the shape 2. Cross all lines to make a point. There must be NO holes in the green outline.
Finalize cadet image on 2D Design. Summarize important points for using 2D Design Observe set up and running of the laser cutter. Compare the quality
Finalize cadet image on 2D Design. Summarize important points
for using 2D Design Observe set up and running of the laser cutter.
Compare the quality of the laser cutter to the Roland MDX-40. 2D
Design Support 1. Use the path tool to draw around the shape 2.
Cross all lines to make a point. There must be NO holes in the
green outline.
Slide 2
Finalize cadet image on 2D Design. Summarize important points
for using 2D Design Observe set up and running of the laser cutter.
Compare the quality of the laser cutter to the Roland MDX-40. 3.
Delete the extra lines 4. There must be NO holes in the green
outline. 2D Design Support
Slide 3
Finalize cadet image on 2D Design. Summarize important points
for using 2D Design Observe set up and running of the laser cutter.
Compare the quality of the laser cutter to the Roland MDX-40. 5. To
fill parts for engraving 6. Click Bound Fill 7. Press ok 2D Design
Support
Slide 4
Finalize cadet image on 2D Design. Summarize important points
for using 2D Design Observe set up and running of the laser cutter.
Compare the quality of the laser cutter to the Roland MDX-40. 5. To
fill parts for engraving 6. Click Bound Fill 7. Press ok 2D Design
Support
Slide 5
Finalize cadet image on 2D Design. Summarize important points
for using 2D Design Observe set up and running of the laser cutter.
Compare the quality of the laser cutter to the Roland MDX-40. 8.
Are there any parts not colored? 9. Click No 2D Design Support
Slide 6
Finalize cadet image on 2D Design. Summarize important points
for using 2D Design Observe set up and running of the laser cutter.
Compare the quality of the laser cutter to the Roland MDX-40. 11.
Click OK 2D Design Support 10. The hole for the key fob. (Inside
cut: RED) 12. Draw the circle
Slide 7
Finalize cadet image on 2D Design. Summarize important points
for using 2D Design Observe set up and running of the laser cutter.
Compare the quality of the laser cutter to the Roland MDX-40.
Inside Cut - RED 2D Design Support Engraved - BLACK Outside cut -
GREEN
Slide 8
LASER CUTTER INSTRUCTIONS Draw your design on 2D Design. Change
the line colors
Slide 9
LASER CUTTER INSTRUCTIONS Use black, red and green from the
bottom box
Slide 10
LASER CUTTER INSTRUCTIONS To set up the laser cutter
