View
122
Download
4
Category
Preview:
Citation preview
Spooky2 How to Find the Strength of Colloid
al Silver
Our Users & Team
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.comor service@spooky2.com
It's hard to find the strength of CS. People often use a TDS meter.
However, colloidal silver is silver particles that are suspended in s
olution – only silver ions are dissolved. So TDS meters will only m
easure the ionic silver strength, not the colloidal strength.
TDS meters measure the conductivity of water, and convert ohms
to ppm.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.comor service@spooky2.com
The CS that Spooky2 makes has an exceptionally high ratio
of CS to ionic silver. The calculator takes the initial TDS readi
ng (only the distilled water – this should be 1 or less) and co
mpares it with the later/final TDS reading.
From the difference in readings, Spooky2 ascertains the true
amount of silver (in ppm, or parts per million) that is in solutio
n.
A more accurate way of determining the ppm is to use a mult
i meter set to milliamps.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.comor service@spooky2.com
Before you begin, set it all up and start a program using any d
well multiplier. Measure the current that passes through one of
the rods by putting the multi meter in series.
This means removing a clip connected to one of the silver rods
and attaching it to one of the multi meter leads. When the other
multi meter lead touches the rod you removed the clip from, a c
urrent will be shown.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.comor service@spooky2.com
Entering this current value into the calculator along with the vol
ume of the water will give a good estimate of the time necessa
ry to make CS.
The current that passes through the solution increases over ti
me as more silver sloughs off the rods. The purpose of the 10k
resistor is to keep the current more constant and low.
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.comor service@spooky2.com
Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com
Email:echolee@cleanenergy-npt.comor service@spooky2.com
Thank you!
Recommended