7
Spooky2 How to Find the Strength of Colloidal Silver Our Users & Team

How to Find the Strength of Colloidal Silver

Embed Size (px)

Citation preview

Page 1: How to Find the Strength of Colloidal Silver

Spooky2 How to Find the Strength of Colloid

al Silver

Our Users & Team

Page 2: How to Find the Strength of Colloidal Silver

Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com

Email:[email protected] [email protected]

It's hard to find the strength of CS. People often use a TDS meter.

However, colloidal silver is silver particles that are suspended in s

olution – only silver ions are dissolved. So TDS meters will only m

easure the ionic silver strength, not the colloidal strength.

TDS meters measure the conductivity of water, and convert ohms

to ppm.

Page 3: How to Find the Strength of Colloidal Silver

Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com

Email:[email protected] [email protected]

The CS that Spooky2 makes has an exceptionally high ratio

of CS to ionic silver. The calculator takes the initial TDS readi

ng (only the distilled water – this should be 1 or less) and co

mpares it with the later/final TDS reading.

From the difference in readings, Spooky2 ascertains the true

amount of silver (in ppm, or parts per million) that is in solutio

n.

A more accurate way of determining the ppm is to use a mult

i meter set to milliamps.

Page 4: How to Find the Strength of Colloidal Silver

Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com

Email:[email protected] [email protected]

Before you begin, set it all up and start a program using any d

well multiplier. Measure the current that passes through one of

the rods by putting the multi meter in series.

This means removing a clip connected to one of the silver rods

and attaching it to one of the multi meter leads. When the other

multi meter lead touches the rod you removed the clip from, a c

urrent will be shown.

Page 5: How to Find the Strength of Colloidal Silver

Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com

Email:[email protected] [email protected]

Entering this current value into the calculator along with the vol

ume of the water will give a good estimate of the time necessa

ry to make CS.

The current that passes through the solution increases over ti

me as more silver sloughs off the rods. The purpose of the 10k

resistor is to keep the current more constant and low.

Page 6: How to Find the Strength of Colloidal Silver

Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com

Email:[email protected] [email protected]

Page 7: How to Find the Strength of Colloidal Silver

Official Support Website: www.spooky2.comOfficial Purchasing Website: www.spooky2-mall.com

Email:[email protected] [email protected]

Thank you!