Magic Bullet NutriBullet Pro Power Cord Replacement · Step 1 — Power Cord Follow steps one and...

Magic Bullet NutriBullet Pro Power CordReplacement

This guide will walk you through the steps necessary to replace the power cord in your MagicBullet Nutri Bullet Pro.

Written By: Malcolm Smith Fraser

Magic Bullet NutriBullet Pro Power Cord Replacement Draft: 2016-12-22Guide ID: 72308 -

This document was generated on 2019-09-25 06:50:20 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 4

INTRODUCTION

If your Magic Bullet Nutri Bullet Pro is not receiving power as a result of a faulty power cord, use thisguide to replace the power cord. To use his guide, first follow steps one and two of the disassemblyguide.

TOOLS:Phillips #0 Screwdriver (1)

Magic Bullet NutriBullet Pro Power Cord Replacement Draft: 2016-12-22Guide ID: 72308 -

This document was generated on 2019-09-25 06:50:20 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 4

Step 1 — Power Cord

Follow steps one and two fromMagic Bullet NutriBullet ProDisassembly before following thesenext steps.

Step 2

Cut the zip tie using scissors.

Magic Bullet NutriBullet Pro Power Cord Replacement Draft: 2016-12-22Guide ID: 72308 -

This document was generated on 2019-09-25 06:50:20 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 4

To reassemble your device, follow these instructions in reverse order.

Step 3

Pull off the rubber covers andseparate the wires using a solderingkit.

Magic Bullet NutriBullet Pro Power Cord Replacement Draft: 2016-12-22Guide ID: 72308 -

This document was generated on 2019-09-25 06:50:20 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 4