EECE 887 Distribution System Engineering CHAPTER 1 Power Delivery Systems

EECE 887 Distribution EECE 887 Distribution System EngineeringSystem Engineering

CHAPTER 1 CHAPTER 1

Power Delivery SystemsPower Delivery Systems

Kansas State University

SUBSYSTEMS

GenerationTransmissionSubtransmissionDistribution

Kansas State University

Billions of Dollars

Generation -- 40%Transmission -- 20%Distribution -- 20%

Kansas State University

MISSION

Reach every customerMeet demands of customersSupply reliable powerProvide fluctuation free voltage Provide power with low harmonicsKeep cost low

Kansas State University

Hierarchical Structure

Source: Willis

Kansas State University

VOLTAGE LEVELS

Generation: 4 kV to 34.5 kV Transmission: 138 kV to 1100 kV Subtransmission: 34.5 kV to 161 kV Distribution (Primary): 4 kV to 34.5

kV (Most common is 12.47 kV) Distribution (Secondary): 120/240 V

Kansas State University

OBSERVATIONS

Transformers separate the levels Equipment size and capacity

decrease as we move down into the system. However, number of equipment increases.

Net capacity increases Reliability drops as we move closer

to customers

Kansas State University

Distribution Service Transformer

Kansas State University

Service Transformer Schematic

Source: Gonen

Kansas State University

Reliability Statistics

Source: Willis

Kansas State University

Further Observations

Transmission Systems:– Very high capacity– Networked for high reliability– Designed to provide system stability

Subtransmission Systems:– Medium capacity– Networked for high reliability– Designed for stability as well as power delivery

needs

Kansas State University

Further Observations

Distribution Substations:– Link between transmission and

distribution– 1 to 6 transformers of 5 MVA to 150 MVA

(generally more than 1 for contingency)– The substation also has high and low

voltage buses, circuit breakers, metering and protective equipment, and a control house.

Kansas State University

Further Observations

Feeders:– Overhead lines mounted on wooden poles

or underground cables (3 to 10 times more expensive than overhead)

– Underground cables used for aesthetics and in dense urban areas.

– 2 to 12 feeders per substation– 2 MVA to 30 MVA per feeder– Radial arrangement

Kansas State University

Dendrillic Configuration

Source: Willis

Kansas State University

Components of Distribution System (Primary side)

Primary trunkMain branches

– Trunk and main branches are usually three-phase

Switches– Normally Closed (NC)– Normally Open (NO)– NO switches are closed during emergencies

Kansas State University

Underground feeder get-away to prevent congestion of wires

Laterals– Branches off of main feeders– one or two phase– Different phases are tapped alternately

to maintain balance– 10 kVA to 2 MVA– Overhead or underground (buried

directly)

Kansas State University

Secondary System

Close to customers at utilization voltage

RadialFeeds 1 to 12 customers (4 to 6

is more common)

Kansas State University

Distribution Secondary

Source: Willis

Kansas State University

What is Distribution System?

– It consists of feeders, service transformers, and secondary system.

– In some cases distribution substation is also included.

– Other equipment: Voltage regulators and tap changers to

maintain voltage levels Capacitors to compensate inductive loads