View
2
Download
0
Category
Preview:
Citation preview
Website: paracordgalaxy.com Email: support@paracordgalaxy.com Phone: 844-727-2267Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our website.
Cobra with Dog Tag Shoelace CharmMaterials
8-10 feet of 550 paracord in one colorOR4-5 feet of 550 paracord in two colors
Shoelace Charm or Dog TagBuckle
{Cost for this project starts at about $3}
1 foot 550 paracord without the inner strands
Step 1: Find the middle of your cord and insert it down through one end of your
buckle.
Step 2: Bring both ends of your paracord down through the loop and pull it tight.
Step 3: Insert the ends of your paracord down through the other end of your
buckle. Measure the desired length for your bracelet.
Step 4: Bring the working end of the cord on the right, A, over your center cords and
under cord B.
Website: paracordgalaxy.com Email: support@paracordgalaxy.com Phone: 844-727-2267Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our website.
Step 5: Bring cord B behind the center cords and up through the loop created by
cord A.
Take your 1 foot piece of paracord and insert one end through the center of the
cords as shown. Then pull A and B tight.
Step 6: Bring A over the center cords as well as your 1 foot piece and under B.
Step 7: Bring B behind the three cords in the center and up through the loop
created by cord A. Pull tight.
Step 8: Lift your 1 foot piece of cord, C. Then take A and cross over the center
cords and under B.
Step 9: Take B behind the center cords and up through the loop created by A,
then pull tight.
Website: paracordgalaxy.com Email: support@paracordgalaxy.com Phone: 844-727-2267Copyright paracordgalaxy.com. You are welcome to use this material if you credit us and link back to our website.
Repeat steps 6 through 9 until you are a little less than half way done. Thread your
dog tag onto cord C as shown.
Continue repeating steps 6 through 9 until you reach the length of your dog tag.
Once you reach the length of your dog tag, insert cord C up through the other end of the tag. Continue with steps 6 through 9 until you reach the end of the bracelet.
Before your last knot, insert cord C down through the center of the cords as shown,
leaving a small loop.
Repeat one last knot with cord A going through the loop in cord C. Pull all cords
tight.
For added security, use forceps to weave cord C under the knots in the back of the
bracelet. Melt and trim all ends.
Recommended