View
2
Download
0
Category
Preview:
Citation preview
95CH8
8. Turret Robot
96CH8
Put up a rubber band between the wheel and the tip of the barrel
on turret to cause tensions. And use 1 DC motor to rotate the gun
turret, ready to shoot at a target.
When the rubber band hung on barrel rotates the wheel to barrel di-
rection, it gets ready to shoot off. On this occasion, the momentum of
the rubber band also increases to the proportion of wheel’s rotating
speed. If the rotating speed of wheel is adjusted, shooting range of
the rubber band is able to be adjusted.
The rotating wheel enables
a rubber band to shoot off.
Rubber
band rack
Introduction
and
how it works
97CH8
X 4 X 8
X 2 X 2
98CH8
X 4
X 4
X 1
99CH8
X 4
X 8 X 4
X 4
100CH8
X 4
101CH8
X 2
X 4 X 4
X 2X 2
102CH8
X 2
103CH8
X 12 X 12
X 8 X 8
X 1 X 1
104CH8
X 1 X 2
X 2
X 2X 2 X 1
105CH8
X 4
106CH8
X 4 X 4
107CH8
X 1
108CH8
M1
M2
M2 M1
completion
Left view
Right view
109CH8
Turret Robot uses program mode 8 to operate.
Connect the rubber band
to the wheel.
1. Load
Move the turret right or left by touching
the right or left sensors.
2. Aim
When the center sensor detects your
hand, the robot will fire the rubber band.
3. Fire
Acting
Module
110CH8
1. Connect the rubber band to the robot. (Do not shoot it at people)
2. Uses paper cups to make a tower with 3~4 floors. Use one cup for the
very top floor. Then, locate your robot 2m away from the tower.
3. Move your turret left and right to aim the robot at the cup on the very top.
When there are many players, set up a time limit of 10~30 seconds. It will
be more fun!
4. After you are done with aiming, fire the rubber band.
5. When the cup at the very top falls down by the rubber band, you will get a
point.
Play the
Game!
Recommended