View
923
Download
7
Category
Preview:
DESCRIPTION
Rubber lined ball sector valves type KSG have been used since1975 in ore dressing plants for throttling control of pulp and abrasive water in connection with mills, thickeners, filters and magnet separators.
Citation preview
Ramén Type KSG
Mounting flange for pneumatic or electric actuators(optional ISO bracket or adapter plate)
3-5 mm
Rubber lined ball sector
Outlet ringeasily replacable
Very favourable shape of thethrottling orifice giving excellentcontrol characteristic and resistance against abrasion(hatched area=flow area)
Maintenance free O-ring seal Maintenance free bearingwith sliding ring of Teflon of Rulon
Short face to face dimension and low weightLow torque for operationEasily adapted to pneumatic or electric actuators for on-off or throttling service
Rubber lined ball sector valves type KSG have been used since1975 in ore dressing plants for throttling control of pulp and abrasive water in connectionwith mills, thickeners, filters and magnet separators.
in valve bodyreducing velocityLarge flow area
Rubber Lined Ball Sector Valve
TB-KSG-E Ramén Trading AB
Box 414, SE-191 24 Sollentuna
www.ramen.se, info@ramen.seTel: 08-594 77970, Fax: 08-96 88 97
070423
soft natural rubber
Low maintenance costs - no lubricationExcellent control characteristic
Features:
The location of the shaft O-ring seal protects the shaft bearing from particlesin the media ensuring long life time with small and retained torque for operation.
TB-KSG-E
Construction
Lockable hand lever with optional indicator scale showing 0-100% of max flow.
Worm gear drive handwheel operator.
Pneumatic cylinder for on-off or throttling service and with positioner.
Electric actuator for on-off or throttling control.
Installation
The valve is flangeless and should be mounted between flanges according to ISO PN10 orANSI 125lb (6" and 8" only). Because of the rubber lining no flange gaskets are required.
Flow direction shall be with the throttling orifice on the outlet side of the valve as indicated insectional drawing above. Thereby the lowest flow velocity is achieved and changing of flow directions in the valve is avoided. Eventual wear will occur only on the outlet ring and ball sector which are easily replaced if necessary. It is recommended that wetted parts of downstream pipe near the valve are rubber lined.
To facilitate mounting of valve and pipes underneath a vessel, flanges may be mountedwith rods on the valve body. Valve type is then read KSGF.
The moving element of the valve is a sector of a ball with pivots journalled in thevalve body. On 90-degree rotation it alters the throttling orifice from fully open to tight shut-off
Valve body, ball sector and outlet ring are soft rubber lined on almost all wetted parts.
The ball sector valve is primarily intended for throttling control but can also be used for
Operation
two position or on-off control.
max. 40-600C depending on temperature and velocityTemperature:Differential pressure: max. ca 3 bar, depending on temperature and media
Working pressure: max 5 bar
of Rulon, O-rings of nitril.
with soft rubber, shaft and bearing sleeve of stainless steel, with bearing
Body, ball sector and outlet ring of nodular iron with wetted parts linedMaterial:
Dimensions:
Capacity: Kvs-values from 95 to 1200DN 80, 100, 125, 150, 200
An outlet ring is integrating the rubber seat that seals off the ball sector.
The ball sector valve is not affected by dynamic forces in throttling position.
It can be equipped with:
Recommended