E³.series - E³.bridge CAD 3D Pro E

3D Harness-Design-Bridge

Technische Informatik GmbHLämmerweg 55D - 89079 Ulm

Telefon: +49 7305/9309-0Fax: +49 7305/9309-99E-Mail: info@cim-team.comInternet: www.cim-team.com

3D Harness Bridge

The 3D Harness Bridge is designed for tranferring data between E³.cable designs and 3D Harness Design Systems

Electrical data from E³.cable• connectors / devices• pins• connectivity• attributes of wires and cables

Data from the 3D Systems• length information

Supported Systems

EMbassy

Pro/ECabling Design

V4V5

Routing

Harness Design

Functionality in the 3D-System

The functionality depends on the 3D System used

Normally supported functions are

• Calculation of wire length• Control of bend radius information• Collision control• Placement of Fixings

Supported E³.series ProEngineer versions

The following versions of E³.series and Pro/E are supported for the interface

• Pro/E 2001 build 2004290• Pro/E Wildfire 1.0 build M240 or later• Pro/E Wildfire 2.0 build M100 or later• E³.series 2004 build 330 or later

Technology (ProEngineer)

Data transfer via XML format – defined by PTC

Structural Data

Connector / Device information

• Device designation• Component name• Serial number• Pin names• Additional attributes

Structural Data

Wire / Cable information

• Wire name• Wire color• Outer Diameter• Bend radius• Additional attributes

• Length information from the 3D system

Prerequisites in E³.cable

Specific attributes for components and pins

Component (Owner: Component)• Type• ArticleNumber (only if selected)• ModelName (only if selected)

Pin (Owner: Pin)• EntryPort• .CONNECTOR_NAME (only if selected) (Internal Device Designation)• InternalLength• PinGrouping

Prerequisites in E³.cable

Specific attributes for wires / cables

Cable (Owner: Cable)• MinimumBendRadius• Diameter

Conductor/Wire (Owner: Cable Conductor)• MinimumBendRadius• Diameter• WireId

Prerequisites in ProE

Mapping of E³.series Component and 3D Model

Mapping through name or attribute ModelName

E³.series 3D Model

Handling

Pro Engineer XML-Export from E³.cable

ProEngineer interface menu

ProEngineer interface – select wires / cables

ProEngineer interface menu

ProEngineer interface – options

ProEngineer interface menu

ProEngineer interface – default values

Default values• used if attributes left

blank• ProE does not allow

blank values

ProEngineer actions

Please ask your ProEngineer specialist

• What prerequisites are necessary• How to read in the XML structure• How to route / control in ProEngineer

DMU in 3D Systems

Automobile Door Harness

Questions and Answers

Any questions ?

CAE solutions

... your cabling solution!

Technische Informatik GmbHLämmerweg 55D - 89079 Ulm

Telefon: +49 7305/9309-0Fax: +49 7305/9309-99E-Mail: info@cim-team.deInternet: www.cim-team.de