×
Log in
Upload File
Most Popular
Art & Photos
Automotive
Business
Career
Design
Education
Hi-Tech
+ Browse for More
sc-chen documents
Documents
Parallel Algorithms for Maximum-Likelihood Nuclear Magnetic Resonance Spectroscopy
Documents
Corn yield model for Ribeirão Preto, São Paulo State, Brazil
Documents
Orbit-lattice coupling parameters for lanthanides in CaF2
Documents
Dynamic crystal field contributions of next nearest neighbour ions in octahedral symmetry
Documents
Preliminary study of polymer melt rheological behavior flowing through micro-channels
Documents
Observation of the polymer melt flow in injection molding process using co-injection molding technique
Documents
Constructing credit auditing and control & management model with data mining technique
Documents
The numerical analysis of strain behavior at the solder joint and interface in a flip chip package
Documents
Largely enhanced coercivity of FePt film at low temperature by introduction of CrRu underlayer
Documents
Thermal analysis of lithium-ion batteries
Documents
Dielectric screening for carbon nanotubes in a gating electric field
Documents
The electrochemical polishing behavior of porous austenitic stainless steel (AISI 316L) in phosphoric-sulfuric mixed acids
Documents
An interfacial investigation of high-dielectric constant material hafnium oxide on Si substrate
Documents
L10 FePt thin films with high coercivity and fine grain by rapid thermal annealing with high heating ramp rate
Documents
High perpendicular hard magnetic properties of nanocomposite Co-rich Co–Pt/Pt double-layered films by epitaxial deposition without capped layer
Documents
Preparation and properties of p-type transparent conductive Cu-doped NiO films
Documents
Film thickness dependence of microstructures and magnetic properties in single-layered FePt films by in-situ annealing
Documents
The Value of Ultrasound-Guided Procedures in the Treatment of Advanced Hepatocellular Carcinoma: Presented with a Case of Extra-Long Survival
Documents
Investigation of the skin melt formation during gas-assisted injection modling
Documents
Simulation of injection-compression mold-filling process
Documents
Effects of Ti underlayer on the degree of order of Fe50Pt50 films
Next >