How to assemble the treadmill

Wire connection

www.jllfitness.co.uk

1. Screw the running deck to the U-type frame. Use the 4 arc washers and the 4 screw caps.

2. Connect the wire from the monitor and the handrail through the plastic clip provided, then push the excess wire into the handrail frame. DO NOT squeeze the wire.

3. Screw the handrail to the upper end of the uprights. Use the 4 black allen head bolts and 4 arc washers. If you cannot screw it, try to move the handle a little bit until you find the right angle.

4. Rotate carefully the console by holding the handrail frame by the place where is connected to the monitor until the

monitor is in a straight position and tighten.

5. Install the hydraulic cylinder using the cylinder screws, flat washers and locking nuts.

6. Install the salver using the tapping screws.

7. Insert the safety key.8. Adjust the pad of U-type frame and

keep the treadmill in a horizontal position.

9. Level the treadmill.10. Set up a normal incline. 11. Plug the treadmill into the wall

outlet and start enjoying the exercise!

1 32

5 6

7

10

• At least two people must lift, move or assemble it.

• Use safe lifting methods.• DO NOT squeeze the wire

Warning: Heavy equipment.

8