“Electricity Generation By Hot Engine Gases”

Presented by Guided by 1. Sonu Kumar Choudhary Mr. Bhupendra Gahlot 2. Nandan yadav (Ass. Prof. of ME dept.)3.Pradeep Kumar Mahato4.Harshwardhan Kumar

CONTENTIntroduction WorkingMajor ComponentsElectricity Generator Advantages/Disadvantages Application Cost Estimation

INTRODUCTION1. We can use the pressure energy of hot gases and we can

convert the kinematic energy in to mechanical work and by mechanical work we can generate electricity.

2. We will install a mechanism with axial high pressure reaction turbines with a backward curved reaction turbine (Exhaust Fan Blade) in a single shaft with a electrical generator.

LAYOUT OF ELECTRICITY GENERATION FROM EXHAUST HOT GASEG

Image of Project

Working/OperationIt will be installed in exhaust system. It will be a mechanism of axial high pressure turbine and

backward curved fan blades with a electrical generator. The air will strike on high pressure reaction turbine and the pressure energy will convert into

mechanical energy. This shaft will also be rotate fan blade that will increase the discharge rate. The improvement in discharge rate will increase the engine power because high pressure

discharge means low pressure drop in exhaust system. If the pressure drop will be low the power will increase of the engine.

The electrical generator will rotated by the same shaft and the electricity will be produced by generator.

Major Components

Backward Curved

Turbine

Electricity Generator

Blower

Guide VanesGuide vanes are very important part in two stage turbine.It will allows the gases from one turbine to another turbine.These guide vanes helps to convert maximum kinetic energy into

mechanical work.

Electricity Generator •This generator convert the mechanical work into electrical energy•This generator is also a DC motor of 12 volt 0.5 MA current•This DC motor will give maximum output on 300 rpm.

Advantages/DisadvantagesAdvantages It is an very economical setup. Engine performance and electricity generation.The electricity can be used in electrical equipments in the vehicles

and to charge the battery.Engine power and performance is also improving by this mechanism.Disadvantages Due to carbon emission the turbine can be choked earlier Electricity generator producing low electricity but it can be improve

by using voltage multipliers.

Application In automobile vehicles like- cars, trucks and bikes also. In Automobile vehicles to charge the mobile phones like in bike.This mechanism use in all types of engine

Thank You