1:2

INTRODUCTION

PART NUMBERING SYSTEM:

Profile Identification and traceability:

The parts list comprises of most of the main parts within the profile and hardware range suitable forCASEMENT WINDOWS.

However, due to the constant addition of new parts, it is recommended that the PROFILE22 ProductCatalogue, is also referred to, this document covers most of the parts within the complete PROFILE22product range.

Profiles:Foiled profiles are nominated in the following ways:Example: A77010D-where prefix “A” is the foil finish in this case Antique Oak (Sherwood), “R” Rosewoodand “M” Mahogany.Suffix “D” denotes that the product is foiled on a (decor), dark brown substrate. If the suffix is “C”, thisdenotes that is on a (caramel) light brown substrate and where the suffix “W” is used followed by anumber as the example shows: A77010W/052, this denotes that the profile is foiled on white profile (oneface only) and the foil in this case Antique Oak is foiled on the 52mm large face.

Profiles are normally marked at approximately 1metre intervals and are marked thus:

22 BS EN :12608:2003 M 11 C 22990 21 1132207

European NormaleStandard to whichprofile is produced

Extrusionline wheremanufactured

113is the113th dayof the year

2200 hrstimeof production

07is the year

ProfilePart Number

TITLESPECIFIC PRODUCT

CASEMENTWINDOW

SUPP.

0

SECTION

CW 1:2

PARTS LIST

PAGE

001TECHNICAL MANUAL

Parts List

ClimaticZone

ImpactHeightClass

WallThickness

DATE REV.

NOV 2006 0 All information in this publication is provided for guidance only and is given in good faith. As it is company policy to continually improve products, methods and materials, changes ofspecification may be made from time to time without prior notice. This statement does not affect your statutory rights.

All dimensions are nominal. DO NOT SCALE

© PROFILE22