PIRANHA

PRODUCT

PRESENTATION

Piranha Range

Piranha Applications• Pumping of faecal matter / heavily polluted sewage• Dewatering tasks using small diameter pipes• Sewage removal in private and communal buildings• Sewage removal from Industrial units• Slaughter houses , food processing plants• Waster removal over undulating terrain

Piranha Advantages

• Piranha system designed by ABS• Vast installation and application experience• Ideal for High head - low flow applications• Pump through small diameter pipe lines• Low installation costs• Shredding system means no blockages

Piranha 08/2• DN 32 threaded discharge• Head Max: H = 21 m• Flow Max: Q = 2 l/s• Single and Three phase

versions• Fixed - Pedestal installation• Free standing installation• Available with float switch• No control box needed

Piranha 08/2 Materials

• Motorhousing - Stainless Steel• Volute/Bottomplate - Cast Iron GG25• Impeller - Plastic• Rotor Shaft - Stainless Steel AISI 420• Fasteners - Stainless Steel AISI 316

• Shredding System - Stainless Steel

Piranha S12 / S26

• DN 32 threaded discharge• Head Max: H = 36 m• Flow Max: Q = 2 l/s• Single or Three phase options• Available in Ex proof version

Performance Curves 50 Hz

Piranha M55- M110

• DN 50 flange discharge• Range of motors• M55/2, M70/2, M85/2, M110/2• Head Max: H = 70 m• Flow Max : Q = 5.5 l/s• Three phase only• Available in Ex proof version

Piranha S12/2-M110/2 Materials

• Motorhousing - Cast Iron GG25

• Volute/Impeller/B’Plate - Cast Iron GG25

• Rotor Shaft - Stainless Steel AISI 420

• Fasteners - Stainless Steel AISI 316

• Shredding System - Hardened Steel

PIRANHA SHREDDING SYSTEM

Shredding Ring

Shredding Rotor

Suction

ShearingMaceration

THE SHREDDING SYSTEMWORKS IN 3 PHASES

Test Procedure as agreed between ABS Wexford and Grontmij Consulting Engineers

Procedure:1. Head is set at 10 metres for Piranha 20 range.

2. The test material is put into the test tank in sequence after the previous item has been shredded.

3. Each full test, (all 13 items), runs for ten minutes in total.

4. Head is measured and recorded at beginning and end of each full test.

5. The volute and back of the Impeller is checked after each full test, photographed and cleaned out.

6. The full test is repeated once more.

Aeration

Rinsing

Blowing Clear ofPressurized sewage pipe lines

COMPRESSOR

Pipe Diameter (mm) 32 50 80 100 150

0.7m/sec Q min in: m3/hr 2.0 4.9 12.7 19.8 44.5 l/s 0.5 1.3 3.5 5.4 12.1

0.5m/sec Q min in: m3/hr 1.4 3.5 9.1 14.0 31.6 l/s 0.35 0.9 2.5 3.8 8.6

MINIMUM FLOW IN PIPE LINES

Pipe Diameter

CONVENTIONAL

PIRANHA

TRENCH SIZE

ORIFACE PLATETo avoid cavitation

New software for Piranha Pressure systems - PAWS

PiranhaVideo Approx 10Duration : mins