Upload
jmurray1949
View
850
Download
4
Tags:
Embed Size (px)
DESCRIPTION
How to setup and run NEC LCD projector.
Citation preview
NEC LT-280 LCD Projector Operating Instructions
Component Parts
Setup Steps in Order
1. Set up Screen and Projector2. Connect Power cables3. Connect LCD Projector to Computer4. Remove Lens Cap from Projector5. Power On LCD Projector6. Power On Computer
Connect Power Cable
Power Cable Plug-in
Connect Projector to Computer (15 Pin LCD Computer Cable)
15 Pin Cable Port
Make sure cable in plugged into “Computer 1 In”
Connect Other End of 15 Pin Computer Cable to VGA Port of your computer
VGA port may be on side of laptop
Remove Lens Cap
Turn on LCD Projector• Projector has two
power switches– A main Power switch
(on back bottom right of LCD Projector)
– A Power Standby button (on top of LCD Projector
Turn on Computer
Boot Up Computer After You Connect And Turn On Projector
Caution!!
• Do not unplug projector or turn off main power switch under any of the following circumstances – You could damage the projector– While projector lamp is lighted– While the cooling fan is running. The cooling fan will
continue to run about 2-3 minutes after the projector is turned off.
– While the PC CARD access indicator lights – doing so can damage your PC memory card.
Caution!!
Adjust Picture Size and Position
• Place Projector on Flat Surface and make sure it is square to screen
• Lift front end of projector to center vertically
• Rotate Projector to center horizontally
Adjust Tilt Foot
1. Lift front end of projector2. Push up the adjustable tilt
foot levers on left and right sides of projector to extend tilt foot
3. Lower front of projector to desired height
4. Release adjustable tilt lever to lock adjustable tilt foot
Zoom and Focus
• Use ZOOM Lever to adjust image size on screen
• Use FOCUS ring to obtain best focus
After Presentation
Powering Down
• Press “On/Standby Button”
• Prompt will appear on screen
• Press “On/Standby Button” again to confirm
Powering Down
Do not unplug projector or turn off main power switch after powering down projector while the cooling fan is running. Computer fan must run to cool off projector – You could damage the projector or bulb.
The cooling fan continues to run 1-2 minutes after the projector is turned off
Powering Down
Replace Lens Cap