Making A Pinhole camera Making A Pinhole camera from a Pringle tube!from a Pringle tube!

By Michael McCauley

WE USED....WE USED....

• Half Pringles tube• Black Sugar paper• Tracking paper• Foil• Elastic band • Scissors• Masking Tape

11stst Step Step

First we had to cut the Pringles tube into two halves because we only needed one half which was the bottom half.

22ndnd Step Step

Then we drew a circle on the sugar paper and cut the circle out in order to place it in the Pringles tube and used blue tac.

Next we mad a hole in the Pringles tube at the tin bit using a compass in order to see the hole if not how else can we see it.

The hole in the Pringles tube.

33rdrd Step Step

44thth Step Step

Next we covered the inside of the tube by covering the inside of the tube with black sugar paper all around inside.

55thth Step Step

After covering, we then closed the open end with tracing paper and secured it tightly with a elastic band.

66thth Step Step

Finally we wrapped the Pringles tube with foil so there is a good look and it would cover the masking tape as well as the Pringles cover.

That’s how we got That’s how we got our pin hole our pin hole camera!camera!

Which Worked Fine!Which Worked Fine!