Upload
narendra019
View
327
Download
10
Embed Size (px)
Citation preview
WELCOME
1
WIRELESS CONTROLLED ROBOTUSING DTMF AND
MICROCONTROLLERDone by:Ch.HarishCh.NarendraT.Bhanu prakashT.Vishnu vardhan
2
DTMF decoder3.5mm audio cable (for connecting mobile to DTMF module)M-8870 decoder ICAT89S52Geared dc motorsBattery (10-12 v)11.0592MHz crystalL293D IC (motor driver)Wheel for motors
BILL OF MATERIALS
3
PROJECT OBJECTIVE To overcome the problem of NLOS and range
problems Approach Using mobile Technology.
Control the robot movement being anywhere in the world.
4
BLOCK DIAGRAM
5
DESCRIPTION OF BLOCK DIAGRAM
Cell phone controlled robots are used to operate the robot by using cell phone. By connecting cell phone to the circuit the cell phone can controlled robot through the by the keypad of cell phone.
6
CELL PHONE Cell phones are used to give the instruction to the
robot by pressing the keypad of the cell phone. The output of the cell phone controls the robot. By generating dual tone, the dual tone is given to
the DTMF decoder; Decoder decodes the frequency into digital data and
controls the robot.
7
8
DTMF RECEIVER SECTION DTMF receiver section is used to receive the dual
tone coming from the cell phone. It is received by the DTMF and decoded by the
same DTMF IC and given to the microcontroller.
9
This DTMF (Dual Tone Multi Frequency) decoder circuit identifies the dial tone from the telephone line and decodes the key pressed on the remote telephone. It employs electronics and computers to support switching operations. DTMF is the ultimate technique used in any of the Mobile, Telephone communication systems.
DTMF DECODER WORKING
10
MICROCONTROLLER Microcontroller will receives the decoded digital
data based on received data. Controller is going to control the robot giving
control signal to the motor driver.
11
Motor Driver ICs are primarily used in autonomous robotics only because microcontrollers couldn’t supply high current and voltage to motors.We have used L293d ic because it can control 4 motors at atime
DRIVER IC
12
CIRCUIT DIAGRAM
13
In this project I have used only 5 keys; they are:2 (for forward movement)4 (for moving left) 5 (for stopping the robot) 6 (for moving right)8 (for backward movement)
PROJECT WORKING
14
Military and Law Enforcement
Search and Rescue
Scientific
Home appliance control
APPLICATIONS
15
FUTURE IMPROVEMENT & SCOPE
IR Sensors
Password Protection
Alarm Phone Dialer
Adding a Camera
16
THANK YOU
17
QUERIES???
18