Attention! Cut the cable tie. Be
careful with the angle sensor.
Attention! The angle sensor must be refitted
first.
Attention! Use a magnetic screwdriver and
tighten the 2 screws in place.
Refit the PSG5 EPM
Scew the driver to the pump
Screw the PSG5 EPM to the pump
Please make sure the insulation of the wires is not damaged. Repair with
supplied heatshrink tubing
Not OK OK
Prepare wires for soldering with solder sleeve by sliding them in each other in the solder sleeve
Solder the wires by heating the solder sleeve with a heat gun or
reduced (yellow) flame
Solder the wires by heating the solder sleeve with a heat gun or
reduced (yellow) flame
Make sure the wires are connected correctly and
solder connections are good (check by pulling).
plugs are located on each side of the pump.
The plugs can be loosened with a hex
key
During assembly It is necessary to fill the pump
with fuel, if air is trapped the engine won’t start. Fuel can be
fed through the plug.