Physical layer-Transmission media
Transmission media are actually located below the physical layer and are directly controlled by the physical layer.
A transmission medium can be broadly defined as anything that can carry information from a source to a destination
The transmission medium is usually free space, metallic cable, or fiber-optic cable.
CS8591-COMPUTERNETWORK-UNIT1 1 /20
Transmission medium and physical layer
CS8591-COMPUTERNETWORK-UNIT1 2 /20
Classes of transmission media
CS8591-COMPUTERNETWORK-UNIT1 3 /20
Twisted-pair cable
Guided media, which are those that provide a conduit from one Guided media, which are those that provide a conduit from one device to another, include twisteddevice to another, include twisted--pair cable, coaxial cable, and pair cable, coaxial cable, and fiberfiber--optic cable.optic cable.
CS8591-COMPUTERNETWORK-UNIT1 4 /20
In a shielded twisted pair (STP), the wires are enclosed in a shield that functions as a grounding mechanism. This is done to provide greater protection from electromagnetic interference and radio frequency interference; however, STP cable is more expensive and difficult to install, compared with UTP.
Unshielded twisted pair (UTP) is a type of copper cabling used in telephone wiring and local area networks (LANs). There are 8 types of UTP cables --identified with the prefix CAT, as in category -- each supporting a different amount of bandwidth.
CS8591-COMPUTERNETWORK-UNIT1 5 /20
CS8591-COMPUTERNETWORK-UNIT1 6 /20
UTP connector
CS8591-COMPUTERNETWORK-UNIT1 7 /20
UTP performance
CS8591-COMPUTERNETWORK-UNIT1 8 /20
Coaxial cable
CS8591-COMPUTERNETWORK-UNIT1 9 /20
Figure 7.9 Coaxial cable performance
CS8591-COMPUTERNETWORK-UNIT1 10 /20
Optical fiber cable
CS8591-COMPUTERNETWORK-UNIT1 11 /20
Figure 7.14 Fiber construction
CS8591-COMPUTERNETWORK-UNIT1 12 /20
CS8591-COMPUTERNETWORK-UNIT1 13 /20
UNGUIDED MEDIA: WIRELESSUNGUIDED MEDIA: WIRELESS
Unguided media transport electromagnetic waves without using a Unguided media transport electromagnetic waves without using a physical conductor. This type of communication is often referred physical conductor. This type of communication is often referred to as wireless communicationto as wireless communication
CS8591-COMPUTERNETWORK-UNIT1 14 /20
Wireless transmission waves
CS8591-COMPUTERNETWORK-UNIT1 15 /20
Electromagnetic spectrum for wireless communication
CS8591-COMPUTERNETWORK-UNIT1 16 /20
Propagation methods
CS8591-COMPUTERNETWORK-UNIT1 17 /20
Bands
CS8591-COMPUTERNETWORK-UNIT1 18 /20
Radio waves are used for multicast communications, such as radio and television, and paging systems. They can penetrate through walls.
Highly regulated. Use omni directional antennas
Microwaves are used for unicast communication such as cellular telephones, satellite networks,and wireless LANs.
Higher frequency ranges cannot penetrate walls. Use directional antennas - point to point line of sight
communications Infrared signals can be used for short-range communication
in a closed area using line-of-sight propagation
CS8591-COMPUTERNETWORK-UNIT1 19 /20
Wireless Channels
Are subject to a lot more errors than guided media channels.
Interference is one cause for errors, can be circumvented with high SNR.
The higher the SNR the less capacity is available for transmission due to the broadcast nature of the channel.
Channel also subject to fading and no coverage holes.
CS8591-COMPUTERNETWORK-UNIT1 20 /20