4
The first week’s online tutorials focused on familiarizing us with the interface of Rhino’s node-based algorithm editor which is Grasshopper. Our first task was to loft two basic sea sponges and explore the general shape. Then, loft two different of sea sponges and try to loft in a similar shape.
First week task:
Moving control points in Rhino to investigate differentiated geometry.
Trying to loft a sea sponge using Rhino only.
5
Exploring new relationships between geometries, investigate differentiated geometry and capturing differentiated models through baking in grasshopper back into Rhino.
6
Week 1 key component:
Point compartment:Contain a collection of three dimensional point
Circle:To create a circle
Number slider:Number slider for single value
Loft:Create lofting surface through a set of section curve
Square Grid:
Recommended