14
8
25
9
7
7
To trim pump power supply
7
Installation Procedure: EVC-E D4/D6 Aquamatic & InboardInstallation Procedure: EVC-E D4/D6 Aquamatic & Inboard
Document number: 47702212
Release date: 06-2012
Joystick
Joystick
Steering wheel
Steering wheel
Multilink hub
Multilink hub
Multilink hub
Multifunction panel(Start/Stop panel)2.5” displays
2.5” display
Levers
Levers
Lever connections
Lever connectionsLever
Lever connections
Buzzer
Buzzer
Actuator
Power-trim pump
Connection for safety lanyard
Steering Control Unit
Buzzer
Connection for safety lanyard
Rudder angle sender (not used)
Rudder angle sender
Fresh water and fuel level senders
Fresh water and fuel level send-ers
Engine
Diagnose connection (VODIA)
FlybridgeDPH twin, electronic steering
Typical installation / Main stationDPH twin, electronic steering
Steering Control UnitDPH twin, electronic steering
Typical installationSingle engine, inboard
IMPORTANT! Never cut or modify the Volvo Penta EVC harnesses. For extra hower supply, use the Volvo Penta relay for external accessories.
Controls
Use template when making holes in dash-board
DPH/DPR connections
Reverse gear connections
Rev. pickup
A
B
Standard–right hand rotation: Connector A to solenoid A Connector B to solenoid B
To POWER TRIM CONN
To trim potentiometer
Gear FWD
Gear REV
Connect shift cable. Lock cable with cotter pin. Power up before connecting shift cable to secure neutral position of actuator.
To GEARSHIFT CONN.
Shift cable bending radius max. 200 mm (8”)
Shift cable fitting down-wards. Cover upper slot with a decal
Mount actuator on transom preferably, angled 5˚ downwards
Clamp steering hoses and cables
To levers, standard EVC bus cable
To engine, ex-tension cable
IMPORTANT! The SCU can be mounted vertically or horizontally. Do NOT mount the SCU with hoses lead-ing up. This will trap air in the hydraulic valve body and cause erratic operation.
Connect power to SCU
Engine starting battery
Main switch
Fuse
Tightening torque: 5 Nm (3.7 lbf.ft)
Helm station
Helm station
To next helm station To next helm station
EngineEngine
IMPORTANT! This end of Y-connector must be con-nected directly, without exten-sion, to levers.
Y-connector
Multiple helm stations
Engine Engine
11 11
10
7
12
5
2
3
11
108
8
8
8
77
8
7
OK!
For information on cable lengths etc. please refer to Installation manual.
NOT OK!
OK!
Connecting multiple Multilink hubs
12
Tilt adjuster bracket
Steering wheel hub
SteeringDPH twin, electronic steering
Joystick
Max. 15 mm (0.59”) dashboard thickness
Steering unit
Docking station DPH twin, electronic steering
Joystick
Stand-alone HCU
Multifunction panel(Docking station panel)
Stand-alone HCU connections
Buzzer
11 11
10
Termination plug
Multisensor
Battery sensor
Battery Control Unit (BCU)
2.5” Battery Management display
Battery
Battery sensor
Compass (CCU)
To NMEA2000 backbone
Autopilot 4” display
2.5” displays
7” display
4” display
Battery Control Unit (BCU)
e-Key panel
11
8
10 1910
11 11
10
12
2121
25
Termination plug 5
5
10
Battery ManagementNegative terminal
Starter motor
Remote frequency reciever with WLAN (RFW)
Continuous output 20 A
B: fused output
A: unfused output
House loads
2.5” Battery Management display
Battery sensor
To engine connector (AUX)
To external switches (optional)
Termination plug
5
e-Key Remote (optional)
Locking/unlocking the boat system. Controls main circuit breaker and two aux relays
e-Key (standard)
Locking/unlocking the boat system
e-Key System
10
1010
11 11
10
e-Key panel
Termination plug
10
7
7
10
Autopilot 4” display
21
7
NMEA2000 backbone
Female terminator
Male terminator
ChartplotterEVC AutopilotCompass (CCU)EVC Autopilot
Battery 12 VDC
T-connectorBackbone ex-tension cable
Fuse
Power cable
23 20
202020Use AUX relay
24 20 22 24
AUX-bus termination
Correct!Termination in the beginning and at the end of the AUX-bus
Incorrect!No end termination of the AUX-bus
Termination plug 5
5
Termination plug
To NMEA 2000 backbone
11
2020
20
Multilink minimum requirements: NOTE! Minimum two 2.5” displays or one 4” or 7” display.Maximum two 4” or 7” displays on one helm station.
NOTE! Minimum one 2.5” display per driveline or one 4” or 7” display. Maximum two 7” displays on one helm station.
47
70
22
12 0
6-2
012
Components and Cables
SteeringControls
Joystick
Incl. cables 1.5 m (5 ft.)
Twin engine levers
Built-in HCUs
Twin engine levers
Built-in HCUs
Powertrim control
Single engine lever
Built-in HCU
Single engine lever
Built-in HCU
Powertrim control
Side mounted
Single engine lever
Built-in HCU
Powertrim control
Steering wheel tilt adjuster Steering wheel hub
Incl. cables 2.5 m (8 ft.)
1b. Wiring harness, Reverse gear / Inboard
Feet Meter Part no.
1 0.3 21865858
Cables
1a. Wiring harness, Stern drive / AQ
Feet Meter Part no.
12.5 3.8 21865856
2. Multisensor Y-split*
Feet Meter Part no.
1.9 0.6 21825662
*) Wiring harness AUX-bus.
3. BM-display Y-split*
Feet Meter Part no.
1.9 0.6 21825656
*) Wiring harness AUX-bus.
24. NMEA2000 Termination plugs
Type Part no.
Male 21812196** Female 21812203**
23. NMEA2000 Powercable
Feet Meter Part no.
6.6 2 21812205**
22. NMEA2000 T-connector
Part no.
21812195**
**) Incl. in Autopilot kit
19. Display cable, 5/6-pin
Feet Meter Part no.
5 1.5 21640400
Incl. in display kit
20. NMEA2000 Extension cable
Feet Meter Part no.
1 0.3 21812185 6.6 2 21812194** 13 4 21867150 19 6 21867151 33 10 21867152
21. Battery sensor cable
Feet Meter Part no.
9.8 3 21840060
17. Steering adapter, 12/6-pin
Feet Meter Part no.
0.6 0.2 21421945
18. Y-split multilink, 6-pin
Feet Meter Part no.
1.6 0.5 3588206
11. Extension cable, 6-pin
Feet Meter Part no.
5 1.5 3889410 10 3.0 3842733 16 5.0 3842734 23 7.0 3842735 30 9.0 3842736 36 11.0 3842737 66 20.0 21172469 131 40.0 21172470
16. Extension cable, 3-pin
Feet Meter Part no.
3 1.0 874759 10 3.0 3807043
12. Sender cable, 6-pin
Feet Meter Part no.
16 5.3 3807229
15. Extension cable, 6-pin
Feet Meter Part no.
5 1.5 21480272
13. Aux. relay cable, 6-pin
Feet Meter Part no.
3.3 1.0 21427463
Kit with cable & relay 12V: 21475508 24V: 21475509
14. Extension cable, 6-pin
Feet Meter Part no.
23 7.0 21166002 30 9.0 21166003 43 13 .0 21166004
7. Standard EVC bus cable, 6-pin*
Feet Meter Part no.
5 1.5 21865234 16 5.0 874789 23 7.0 889550 30 9.0 889551 36 11.0 889552 42 13.0 888013
*) One cable per engine has to be ordered.
8. Y-connector, 6-pin
Feet Meter Part no.
1.6 0.5 3588972
10. Multilink cable, 6-pin
Feet Meter Part no.
5 1.5 3886666
6. Y-split steering, 6-pin
Feet Meter Part no.
1.3 0.4 21421941
9. 7” display cable, 6-pin
Feet Meter Part no.
5.5 1.7 21514712*
*) Incl. in display kit
5. Termination plug
Part no.
21825714
Steering wheel non tilt adjuster
Single engine lever
Built-in HCU
Side mounted
Fresh water level **
Diameter 52 mm (2.05”)
EVC system tachometer
Diameter 85 mm (3.35”) 110 mm (4.33”) 0–4000 rpm
Coolant temp **
Diameter 52 mm (2.05”) C°, F°
Speedometer Unitless **
Diameter 85 mm (3.35”) 110 mm (4.33”)
0–40 1/Hour 0–60 1/Hour
Alarm instrument **
Diameter 52 mm (2.05”)
Voltmeter **
Diameter 52 mm (2.05”) 12 V, 24 V
Rudder indicator **
Diameter 52 mm (2.05”)
Front ring kit (nut)
Diameter 52 mm (2.05”) Black/Chrome
Diameter 85 mm (3.25”) Black/Chrome
Diameter 110 mm (4.33”) Black/Chrome
Front ring kit (clamp)
Diameter 52 mm (2.05”) Black/Chrome
Diameter 85 mm (3.25”) Black/Chrome
Fuel level **
Diameter 52 mm (2.05”)
Engine oil pressure **
Diameter 52 mm (2.05”) bar, psi
Turbo pressure **
Diameter 52 mm (2.05”) bar, psi
4-in-1 Gauge **
Diameter 110 mm (4.33”) Coolant temperature Voltage Oil pressure Fuel level
Aux. Dimmer Unit (ADU) **
Instruments**) Only in combination with EVC system tachometer
1616 10 10ADU
NMEA interface
Trim instrument **
Diameter 52 mm (2.05”) analog
Trim instrument **
Diameter 52 mm (2.05”) digital
Components
Sender
Fuel level sender 3–180 ohm
Fuel level sender 240–30 ohm
Sender
Water level sender 3–180 ohm
Stand-alone HCU e-Key panel
Ignition, start/stop and locking/unlocking the boat system
Multilink hub
6 cable sockets
Autopilot interface NMEA 0183 interface NMEA 2000 interface
7” display power supply for 12 V systems
Multisensor
Transom mounted
A-CAN
Analog lever interface
Multisensor
Hull mounted
SCU
Steering Control Unit
7” display
Color display
Autopilot 4” display
Color display
4” display
Color display
Rudder angle sensor
3–180 ohm
Remote frequency reciever
with WLAN (RFW)
Battery Control Unit Battery sensore-KeyCompass (CCU)
Not in combination with 2.5” or 7” display
Not in combination with 2.5” or 4” display
e-Key Remote
25. e-Key harness with Safety lanyard
Feet Meter Type Part no.
5 1.5 Single panel 21693202 5 1.5 Twin panel 21693206
26. e-Key harness without Safety lanyard
Feet Meter Type Part no.
5 1.5 Single panel 21693204 5 1.5 Twin panel 21693208
2.5” display
Not in combination with 4” or 7” display
Multifunction panel
Function configured at startup
10