HLR - HLR SSAP Version 1Interface Specification
DN99633396Issue 6-0 en
# Nokia Siemens Networks 1 (19)
MSCDOCM14PDFCDMSC/HLR, Rel. M14.1, Product Documentation,v.1
The information in this document is subject to change without notice and describes only theproduct defined in the introduction of this documentation. This documentation is intended for theuse of Nokia Siemens Networks customers only for the purposes of the agreement under whichthe document is submitted, and no part of it may be used, reproduced, modified or transmitted inany form or means without the prior written permission of Nokia Siemens Networks. Thedocumentation has been prepared to be used by professional and properly trained personnel,and the customer assumes full responsibility when using it. Nokia Siemens Networks welcomescustomer comments as part of the process of continuous development and improvement of thedocumentation.
The information or statements given in this documentation concerning the suitability, capacity, orperformance of the mentioned hardware or software products are given “as is” and all liabilityarising in connection with such hardware or software products shall be defined conclusively andfinally in a separate agreement between Nokia Siemens Networks and the customer. However,Nokia Siemens Networks has made all reasonable efforts to ensure that the instructionscontained in the document are adequate and free of material errors and omissions. NokiaSiemens Networks will, if deemed necessary by Nokia Siemens Networks, explain issues whichmay not be covered by the document.
Nokia Siemens Networks will correct errors in this documentation as soon as possible. IN NOEVENT WILL NOKIA SIEMENS NETWORKS BE LIABLE FOR ERRORS IN THISDOCUMENTATION OR FOR ANY DAMAGES, INCLUDING BUT NOT LIMITED TO SPECIAL,DIRECT, INDIRECT, INCIDENTAL OR CONSEQUENTIAL OR ANY LOSSES, SUCH AS BUTNOT LIMITED TO LOSS OF PROFIT, REVENUE, BUSINESS INTERRUPTION, BUSINESSOPPORTUNITY OR DATA, THAT MAYARISE FROM THE USE OF THIS DOCUMENT OR THEINFORMATION IN IT.
This documentation and the product it describes are considered protected by copyrights andother intellectual property rights according to the applicable laws.
The wave logo is a trademark of Nokia Siemens Networks Oy. Nokia is a registered trademark ofNokia Corporation. Siemens is a registered trademark of Siemens AG.
Other product names mentioned in this document may be trademarks of their respective owners,and they are mentioned for identification purposes only.
Copyright © Nokia Siemens Networks 2008. All rights reserved.
2 (19) # Nokia Siemens Networks DN99633396Issue 6-0 en
HLR - HLR SSAP Version 1 Interface Specification
Contents
Contents 3
List of tables 4
1 Introduction 5
2 Interface modifications 72.1 General description 72.2 Changes of interface after previous release 7
3 Interface description 93.1 Dialogue procedures 93.2 CCBS Operations 93.3 Parameters 103.4 Support of CCBS operation parameters 113.4.1 Operations 113.4.1.1 CcbsRequest 113.4.1.2 CcbsCancel 123.4.1.3 RemoteUserFree, CcbsSuspend, and CcbsResume 123.5 Restrictions 133.5.1 Restrictions to charging 133.5.2 Restrictions to statistics 13
4 Support protocol description 15
Glossary 17
References 19
DN99633396Issue 6-0 en
# Nokia Siemens Networks 3 (19)
Contents
List of tables
Table 1. The SSAP dialogue procedures. 9
Table 2. The CCBS operations. 10
Table 3. The SSAP parameters. 10
Table 4. The CcbsRequest operation (ETS 300 356-18, Table C.1). 11
Table 5. The CcbsCancel operation (ETS 300 356-18, Table C.1). 12
Table 6. The RemoteUserFree, CcbsSuspend, and CcbsResume operation (ETS300 356-18, Table C.1). 12
Table 7. The coding of subscriber B's address in the SCCP. 15
4 (19) # Nokia Siemens Networks DN99633396Issue 6-0 en
HLR - HLR SSAP Version 1 Interface Specification
1 Introduction
The purpose of this document is to describe the Supplementary ServiceApplication Part (SSAP) interface between the originating and target HLR.
The SSAP is an interface protocol which provides the signalling functionsbetween the originating and target exchange for the Completion of Calls toBusy Subscribers (CCBS) supplementary service.
The SSAP uses the services provided by the Transaction CapabilityApplication Part (TCAP) to transfer information between originating andtarget HLR.
This document covers the Supplementary Service Application Part (SSAP)specified by the European Telecommunication Standards Institute (ETSI)in ETS 300 356-18 (February 1995).
DN99633396Issue 6-0 en
# Nokia Siemens Networks 5 (19)
Introduction
6 (19) # Nokia Siemens Networks DN99633396Issue 6-0 en
HLR - HLR SSAP Version 1 Interface Specification
2 Interface modifications
2.1 General description
The HLR - HLR SSAP Version 1 is an interface which uses the servicesprovided by the Transaction Capability Application Part (TCAP) to transferinformation between the originating and target HLR. The SSAP interfaceprotocol provides the signalling functions between the originating andtarget exchange for the Call Completion to Busy Subscriber (CCBS)supplementary service.
2.2 Changes of interface after previous release
No changes have been implemented in the interface since the previousrelease.
DN99633396Issue 6-0 en
# Nokia Siemens Networks 7 (19)
Interface modifications
8 (19) # Nokia Siemens Networks DN99633396Issue 6-0 en
HLR - HLR SSAP Version 1 Interface Specification
3 Interface description
3.1 Dialogue procedures
The Supplementary Service Application Part (SSAP) dialogue proceduresare introduced in the following table.
The following abbreviations are used in the table below:
D descriptive text
S supported
Table 1. The SSAP dialogue procedures.
Reference
ETS 300 356-18
Nokia's support
9.9 Dialogue D
9.9.1 General D
9.9.2 Dialogue beginning S
9.9.3 Dialogue continuation S
9.9.4 Dialogue end S
3.2 CCBS Operations
The following abbreviation is used in the table below:
S supported
DN99633396Issue 6-0 en
# Nokia Siemens Networks 9 (19)
Interface description
Table 2. The CCBS operations.
CCBS Operation Reference
ETS 300 356-18
Nokia's support
CcbsRequest 9.1 S
CcbsCancel 9.1 S
RemoteUserFree 9.2 S
CcbsSuspend 9.2 S
CcbsResume 9.2 S
3.3 Parameters
The following abbreviations are used in the table below:
S supported
PS partially supported
NS not supported
Table 3. The SSAP parameters.
Parameter Reference
ETS 300 356-18
Nokia's support
calledPartyNumber Table C.1 ¹) S
retainSupported Table C.1 S
userServiceInf Table C.1 ¹) S
callingPartyNumber Table C.1 ¹) NS
userServiceInfPrime Table C.1 ¹) NS
accessTransportParameter Table C.1 ²) PS ³)
cancelCause Table C.1 S
10 (19) # Nokia Siemens Networks DN99633396Issue 6-0 en
HLR - HLR SSAP Version 1 Interface Specification
Note
1. The parameter is structured as described in ITU-TRecommendations Q.763 (1999), Specifications of SignalingSystem No.7.
2. The parameter is structured as described in ITU-TRecommendations Q.931 (1998), Digital Subscriber SignalingSystem No.1; Network Layer.
3. The High Layer Compatibility (HLC), Lower Layer Compatibility(LLC), and called party subaddress are present. The calling partysubaddress is not present.
3.4 Support of CCBS operation parameters
The following abbreviations are used in the tables below:
M mandatory parameter
O optional parameter
S supported
PS partially supported
NS not supported
3.4.1 Operations
3.4.1.1 CcbsRequest
Table 4. The CcbsRequest operation (ETS 300 356-18, Table C.1).
ETSI use Nokia's support
Invocation Parameters
calledPartyNumber M S
retainSupported M S
userServiceInf O S
callingPartyNumber O NS
userServiceInfPrime O NS
DN99633396Issue 6-0 en
# Nokia Siemens Networks 11 (19)
Interface description
Table 4. The CcbsRequest operation (ETS 300 356-18, Table C.1). (cont.)
ETSI use Nokia's support
accessTransportParameter O PS ¹)
Result Parameters
retainSupported M S
Error Causes
ShortTermDenial M S
LongTermDenial M S
Note
1. The calling party subaddress is not present.
3.4.1.2 CcbsCancel
Table 5. The CcbsCancel operation (ETS 300 356-18, Table C.1).
Parameter ETSI use Nokia's support
cancelCause O S
3.4.1.3 RemoteUserFree, CcbsSuspend, and CcbsResume
Table 6. The RemoteUserFree, CcbsSuspend, and CcbsResume operation(ETS 300 356-18, Table C.1).
Parameter ETSI use Nokia's support
(no parameters)
12 (19) # Nokia Siemens Networks DN99633396Issue 6-0 en
HLR - HLR SSAP Version 1 Interface Specification
3.5 Restrictions
3.5.1 Restrictions to charging
When the SSAP connection is used, the length of the connection is notchargeable. Fixed charging can be used to charge the initiation of theconnection.
3.5.2 Restrictions to statistics
The SSAP protocol statistics can only be measured in the originating anddestination signalling points. No statistics are available for transit signallingpoints where routing (of messages) is done on the MTP level.
It is not possible to distinguish the GSM type of CCBS from the ISDN typeof CCBS in the SSAP operation specific counters.
DN99633396Issue 6-0 en
# Nokia Siemens Networks 13 (19)
Interface description
14 (19) # Nokia Siemens Networks DN99633396Issue 6-0 en
HLR - HLR SSAP Version 1 Interface Specification
4 Support protocol description
The SSAP uses the services of the underlying layers: the TCAP(Transaction Capabilities Application Part) and SCCP (SignallingConnection Control Part). The TCAP used complies with the ITU-Trecommendations.
The SCCP service class is “1”, meaning that the messages are received inthe order they are sent. The SCCP return option is set to “return messageon error” by default.
For routing on the international interface and for routing based on theGlobal Title (GT) translation mechanism within national networks, thecoding of subscriber B's address in the SCCP complies with the followingrestrictions:
Table 7. The coding of subscriber B's address in the SCCP.
Variable Value Explanation
SSN indicator 1 SSN for ISDN supplementary services is alwaysincluded.
GT indicator 0100 Includes the translation type, numbering plan,encoding scheme, and nature of the address.
translation type 0001 0001 Translation table.
numbering plan 0001 ISDN/telephony numbering plan E.164.
routing indicator 0 Routing on global title.
For routing within a national network, the SCCP addressing method basedon the Signalling Point Codes (SPCs) may be used.
The subsystem number value 0000 1011 (0xB) is dedicated to the ISDNsupplementary services ASEs.
DN99633396Issue 6-0 en
# Nokia Siemens Networks 15 (19)
Support protocol description
16 (19) # Nokia Siemens Networks DN99633396Issue 6-0 en
HLR - HLR SSAP Version 1 Interface Specification
Glossary
ApplicationServiceElement(ASE)
A set of functions that provides a capability for the interworking ofapplication entity invocations for a specific purpose on a single applicationassociation.
Completion ofCalls to BusySubscriber(CCBS)
A service which enables subscriber A who has called a busy line to havethe call completed automatically when the called line becomes free withouthaving to redial the called number.
Global Title(GT)
An address, such as digits dialled by the customer, which requires anaddress conversion before the messages are sent to Message TransferPart (MTP).
IntegratedServicesDigitalNetwork(ISDN)
Integrated services network that provides digital connections betweenuser-network interfaces.
SignallingConnectionControl Part(SCCP)
Part of CCS7 signalling; provides connectionless and connection-orientedservices to achieve compatibility with the Open Systems Interconnection(OSI) network layer.
Supplemen-tary ServiceApplicationPart (SSAP)
The SSAP is an interface protocol which provides the signaling functionsbetween the originating and target exchange for the Call Completion toBusy Subscriber (CCBS) and Completion of Calls on No Reply (CCNR)supplementary services.
SubsystemNumber (SSN)
A number to identify a subsystem using the Signalling Connection ControlPart (SCCP) either directly, like the ISDN user part, or indirectly (via thetransaction capabilities) like the Operations, Maintenance andAdministration part (OMAP).
TransactionCapabilitiesApplicationPart (TCAP)
A part of the transaction capabilities that resides in the application layer ofthe OSI protocol references model.
DN99633396Issue 6-0 en
# Nokia Siemens Networks 17 (19)
Glossary
18 (19) # Nokia Siemens Networks DN99633396Issue 6-0 en
HLR - HLR SSAP Version 1 Interface Specification
References
1. ETS 300 356-18 (February 1995) Integrated Services DigitalNetwork (ISDN); Signalling System No.7; ISDN User Part (ISUP)version 2 for the international interface; Part 18: Completion of Callsto Busy Subscribers (CCBS) supplementary service.
2. ITU-T Recommendations Q.763 (1999), Formats and codes of theISDN user part of Signalling System No. 7 .
3. ITU-T Recommendations Q.931 (1998), Digital SubscriberSignalling System No. 1 (DSS 1) - ISDN User-Network InterfaceLayer 3 Specification For Basic Call Control.
DN99633396Issue 6-0 en
# Nokia Siemens Networks 19 (19)
References